Abstract:This study dealt with the synthesis of pure and Sn-doped CuO with different concentrations ( x = 0.000, 0.005, and 0.010) capped with ethylenediaminetetraacetic acid (EDTA) through the simple and low-cost co-precipitation method. The synthesized nanoparticles are further characterized by x-ray diffraction to determine their structural properties. The crystalline size is decreased to 37.06 nm upon increasing the concentration of Sn dopant. Also, Sn doping has a remarkable effect on CuO, where it was observed with smaller and spherical particles that are confirmed from the SEM results. Also, EDX confirmed the excellent compositional homogeneity that verified that Sn is a real dopant in CuO. Ultraviolet-visible spectroscopy is used to determine the optical properties of the Sn-doped CuO nanoparticles in propanol solvent. The Tauc plots are used to estimate the band gap energies. These nanoparticles are found to be excitation-dependent which is proved by using photoluminescence spectroscopy. Also, they can be used as a potential candidate for blue-chip and are applicable in near-UV white light emitting devices. Consequently, these nanoparticles have been used as corrosion inhibitors with 77% efficiency on mild steel in 0.5 M HCl which is confirmed by electrochemical impedance spectroscopy measurements. The potentiodynamic polarization studies classified these nanoparticles as mixed-type inhibitors that form a protective film on the mild steel surface. This was confirmed by Raman spectra in 0.5 M HCl where the corrosion products formed were detected and analyzed.

The Behavior and Effect of CuO in Ag/SnO2 Materials

Influences of Tin Oxide Surface Modification on the Morphology and Performance of Sintered Ag/SnO2 Composite Powders

How Cu Doping Improves the Interfacial Wettability Between Ag and SnO2 of Ag/SnO2 Contact Material

Effect of CuO additive on the wettability and interface behavior of silver/tin oxide

Preparation of CuO-Ag/SiO2 nano-composites via adsorption phase reaction technique

Microstructure and Properties of Ag–SnO2 Materials with High SnO2 Content

Surface Morphology, Electrochemical and Electrical Performances of ZnO Thin Films Sensitized with Ag Nanoparticles by UV Irradiation

Transformation of CuO Nanoparticles in the Aquatic Environment: Influence of Ph, Electrolytes and Natural Organic Matter

Influences of Metal Oxide Additions on the Morphology of Sintered AgSnO2 Composite Powders

Research on Arc Erosion Products on Silver-metal Oxide Contacts Materials

Preparation and Arc Erosion Mechanism of Ni Skeleton Reinforced Ag-Based Contact Materials with CuO-Coated SnO2

Effect of the impurity in electroless plated Powders on morphology and properties of sintered AgSnO2 materials

Effects of Ag Nanoparticles on the Visible-Light-driven Photocatalytic Properties of Cu2O Nanocubes

Tailoring the Structural, Optical and Anti-corrosion Effect of Synthesized Sn-Doped CuO Nanoparticles on Mild Steel in 0.5 M HCl Solution

Electrical Performance of Cu Doped AgSnO<sub>2</sub>In<sub>2</sub>O<sub>3</sub> Electrical Contacts Fabricated by Internal Oxidation

Oxidation behavior and mechanism of Ag-9.8Sn-1.3Bi-0.4Cu alloy powders in different oxidant

Microstructure and Properties of Ag/SnO2 Coatings Prepared by Cold Spraying

Contact Resistance Characteristics of Ag–SnO2 Contact Materials with High SnO2 Content

Exploration of the Influence Mechanism of La Doping on the Arc Erosion Resistance of Ag/SnO2 Contact Materials by a Laser-Simulated Arc

Effect of La2Sn2O7 content on Ag-La2Sn2O7/SnO2 arc erosion behavior and mechanism

Investigation of the Optical and Dielectric Behaviour of SnO2-CuO Mixed Oxides Thin Films