Tailoring the Structural, Optical and Anti-corrosion Effect of Synthesized Sn-Doped CuO Nanoparticles on Mild Steel in 0.5 M HCl Solution

M. Y. El Sayed,Nour El Ghouch,G. O. Younes,M. Noun,R. Awad
DOI: https://doi.org/10.1007/s11665-024-09205-z
IF: 2.3
2024-02-09
Journal of Materials Engineering and Performance
Abstract:This study dealt with the synthesis of pure and Sn-doped CuO with different concentrations ( x = 0.000, 0.005, and 0.010) capped with ethylenediaminetetraacetic acid (EDTA) through the simple and low-cost co-precipitation method. The synthesized nanoparticles are further characterized by x-ray diffraction to determine their structural properties. The crystalline size is decreased to 37.06 nm upon increasing the concentration of Sn dopant. Also, Sn doping has a remarkable effect on CuO, where it was observed with smaller and spherical particles that are confirmed from the SEM results. Also, EDX confirmed the excellent compositional homogeneity that verified that Sn is a real dopant in CuO. Ultraviolet-visible spectroscopy is used to determine the optical properties of the Sn-doped CuO nanoparticles in propanol solvent. The Tauc plots are used to estimate the band gap energies. These nanoparticles are found to be excitation-dependent which is proved by using photoluminescence spectroscopy. Also, they can be used as a potential candidate for blue-chip and are applicable in near-UV white light emitting devices. Consequently, these nanoparticles have been used as corrosion inhibitors with 77% efficiency on mild steel in 0.5 M HCl which is confirmed by electrochemical impedance spectroscopy measurements. The potentiodynamic polarization studies classified these nanoparticles as mixed-type inhibitors that form a protective film on the mild steel surface. This was confirmed by Raman spectra in 0.5 M HCl where the corrosion products formed were detected and analyzed.
materials science, multidisciplinary
What problem does this paper attempt to address?