Abstract:In the last few years, due to the large amount of greenhouse gas emissions causing environmental issue like global warming, methods for the full consumption and utilization of greenhouse gases such as carbon dioxide (CO2) have attracted great attention. In this study, a packed-bed dielectric barrier discharge (DBD) coaxial reactor has been developed and applied to split CO2 into industrial fuel carbon monoxide (CO). Different packing materials (foam Fe, Al, and Ti) were placed into the discharge gap of the DBD reactor, and then CO2 conversion was investigated. The effects of power, flow velocity, and other discharge characteristics of CO2 conversion were studied to understand the influence of the filling catalysts on CO2 splitting. Experimental results showed that the filling of foam metals in the reactor caused changes in discharge characteristics and discharge patterns, from the original filamentary discharge to the current filamentary discharge as well as surface discharge. Compared with the maximum CO2 conversion of 21.15% and energy efficiency of 3.92% in the reaction tube without the foam metal materials, a maximum CO2 decomposition rate of 44.84%, 44.02%, and 46.61% and energy efficiency of 6.86%, 6.19%, and 8.85% were obtained in the reaction tubes packed with foam Fe, Al, and Ti, respectively. The CO2 conversion rate for reaction tubes filled with the foam metal materials was clearly enhanced compared to the non-packed tubes. It could be seen that the foam Ti had the best CO2 decomposition rate among the three foam metals. Furthermore, we used density functional theory to further verify the experimental results. The results indicated that CO2 adsorption had a lower activation energy barrier on the foam Ti surface. The theoretical calculation was consistent with the experimental results, which better explain the mechanism of CO2 decomposition.

Decomposition of dimethylamine gas with dielectric barrier discharge.

Energy efficiency optimization for H2S removal by dielectric barrier discharge plasma

Abatement of Malodorants from Pesticide Factory in Dielectric Barrier Discharges.

Decomposition of Dimethyl Sulfide in Dielectric Barrier Plasma Discharge Assisted by Active Carbon

Decomposition of Dimethyl Sulfide in a Wire-Cylinder Pulse Corona Reactor

Destruction of Dimethyl Disulfide in a Gas Flow System with Dielectric Barrier Discharge

Influence of balance gas mixture on decomposition of dimethyl sulfide in a wire-cylinder pulse corona reactor.

Decomposition of Dimethyl Sulfide with Non-Thermal Plasma Induced by Dielectric Barrier Discharge

Removal of N,N-dimethylformamide by dielectric barrier discharge plasma combine with manganese activated carbon

Removal of ammonia from gas streams with dielectric barrier discharge plasmas

Abatement of Isobutyl Acetate Waste Gas with Dielectric Barrier Discharge

High Concentration Xylene Decomposition and Diagnostic Analysis by Non-Thermal Plasma in A Dbd Reactor

Humidity and Oxygen Effects on Dimethyl Sulfide Decomposition Plasma Corona Reactor

Application of Non-Thermal Plasma Technology on Fugitive Methane Destruction: Configuration and Optimization of Double Dielectric Barrier Discharge Reactor

CO2-CH4 conversion and syngas formation at atmospheric pressure using a multi-electrode dielectric barrier discharge

DBD Plasma Combined with Different Foam Metal Electrodes for CO2 Decomposition: Experimental Results and DFT Validations

Photocatalytic degradation of dimethylamine in wastewater with nano-TiO;/diatomite

Removal of Isobutyl Acetate in Flowed Air Stream with DBD Plasmas

Removal of formaldehyde by a pulsed dielectric barrier discharge in dry air in the 20 °C to 300 °C temperature range

Direct Decomposition of No Activated by Microwave Discharge

Dual-course dielectric barrier discharge with a novel hollow micro-holes electrode to efficiently mitigate NO x