Abstract:The Euler–Lagrange method is a great way for multiphase bubble flow simulation, the detailed information of bubbles can be effortlessly obtained, and it is helpful for the efficiency and safety of different industry processes. Traditionally, the computational fluid dynamics-discrete bubble model (CFD-DBM) method has always been used to simulate this flow process. Nevertheless, the ability of the traditional CFD-DBM method is significantly limited in terms of the size ratio between the grid and bubble, where the grid size must be larger than the bubble size. In reality, the bubble may be larger than the grid and the grid/bubble size ratio can be very large due to the effects of complex bubble dynamics (such as the bubble breakup and coalescence) and complex internal flows. To address this issue, an improved CFD-DBM method is proposed in this study, which can be used for the simulation with a wide grid/bubble size ratio in gas–liquid–bubble multiphase simulation, and the volume of fluid (VOF) method is applied to capture the interface between gas and liquid phases. A gradient-based interpolation method is employed to reconstruct the liquid velocity around the target bubble when the grid size is much larger than the bubble size. If the bubble size is comparable with or larger than the grid size, the interphase force correction and the field smoothing will be carried out within a spherical support area. Subsequently, the proposed model is validated by the comparison with a bubble column experiment, in terms of the bubble size distribution and bubble vertical velocity. The results demonstrate the high accuracy of the new method. Finally, the influence of different parameters including normal spring stiffness, critical Weber number, and the range of the spherical support area on the bubble flow is investigated.

Flow Simulations for NASA CRM Wing-Body-Tail with Implicit Hole Cutting Method

Unsteady Flow Simulation of a Variable-Sweep Morphing Aircraft Coupled with Flight Control System

Experimental Validation of Nonlinear Coupled Constitutive Relations in Continuum Flows

Computation of Hypersonic Flows over Flying Configurations Using a Nonlinear Constitutive Model

Computational Simulation of Reentry Flows over Hypersonic Vehicles Using Nonlinear Coupled Constitutive Relations

Constrained Large-Eddy Simulation and Detached Eddy Simulation of Flow Past a Commercial Aircraft at 14 Degrees Angle of Attack

A Computational Strategy for Nonlinear Coupled Constitutive Relations of Rarefied Nonequilibrium Flows on Unstructured Grids

Simulations of Interaction Between Flow and a Thin Elastic Beam Using Cip-Based Model with Adaptive Mesh

Numerical Simulations of Complex Aircraft Configurations Using Structured Overset Grids with Implicit Hole-Cutting

An Improved CIP-based Numerical Model for Simulating Free-Surface Flow with Adaptive Mesh

An Improved Computational Fluid Dynamics-Discrete Bubble Model for Multiphase Bubble Flow Simulation with a Wide Grid/bubble Size Ratio

Grid Convergence Study on a Finite Volume Code NSAWET

Numerical Investigations Of The Jaxa High-Lift Configuration Standard Model With Mflow Solver

F-16XL Hybrid Reynolds-Averaged Navier-Stokes/Large Eddy Simulation on Unstructured Grids

Numerical Simulation Of Free Surface Flow With An Elastic Plate Using A Cip-Based Model

Investigation of Practical Flow Control Methodologies with RANS/LES Hybrid Methods

Study of Transonic Separated Flows with zonal-DES Based on Weakly Non-linear Turbulence Model

Efficient Numerical Techniques for Simulating a Rotorcraft Flow Field with Overlapping Grids

A Modular RANS Approach for Modeling Hypersonic Flow Transition on an Air-Breathing Configuration

Numerical Investigation of Control Surfaces Deflection

Research on Computational Method of Supersonic Inlet/Isolator Internal Flow