Abstract:In the research field of rotorcraft aerodynamics, there are two fundamental challenges: resolving the complex vortex structures in rotor wakes and representing the moving rotor blades in the ambient airflow. In this paper, we address the first challenge by utilizing a third-order unstructured finite volume solver, which exhibits lower numerical dissipation than its second-order counterpart. This allows for sufficient resolution of small vortex structures on relatively coarse meshes. With this flow solver, the second challenge is addressed by modeling each rotor as an actuator disk (i.e., the actuator disk model (ADM)) or modeling each blade as an actuator line (i.e., the actuator line model (ALM)). Both of the two models are equipped with an improved tip loss correction, which is introduced in detail in the methodology section. In the section of numerical experiments, the numerical convergence properties of the two types of solvers have been compared in the case of two-dimensional infinite wing. In addition, the relationship between the ALM and the lifting line theory is discussed in the cases of fixed-wing calculations. Another goal of these cases is to validate the tip loss correction presented. The validation of the ALM/ADM and comparisons of computational efficiency are also demonstrated in simulations involving both hover and forward flight rotors. It was found that the combination of the third-order finite volume solver and the ALM/ADM with the improved tip loss correction presents an efficient way of performing the aerodynamic analysis of rotor-induced downwash flow.

Numerical Simulations of Complex Aircraft Configurations Using Structured Overset Grids with Implicit Hole-Cutting

Constrained Large-Eddy Simulation and Detached Eddy Simulation of Flow Past a Commercial Aircraft at 14 Degrees Angle of Attack

Numerical Simulation of the Performance of the Sc-89 Jet Impact System

Navier-Stokes Simulations for Transport Aircraft Wing/Body High-Lift Configurations

Numerical Investigation of Control Surfaces Deflection

Efficient Numerical Techniques for Simulating a Rotorcraft Flow Field with Overlapping Grids

Numerical investigation of an advanced aircraft model during pitching motion at high incidence

Aerodynamic Simulation of a Typical Multirotor e VTOL Aircraft Configuration.

A Method for Grid Generation in Numerical Flow Analysis of Complex Configurations

Numerical Investigations Of The Jaxa High-Lift Configuration Standard Model With Mflow Solver

Numerical Simulation on Aerodynamic Characteristics of Transition Section of Tilt-Wing Aircraft

Research and Application of Discrete Adjoint Optimization based on Unstructured Grid

Numerical Simulation of Separated Flow Via 2D Hybrid Grid Technique

Numerical studies of static aeroelastic effects on grid fin aerodynamic performances

An efficient grid assembling method in unsteady dynamic motion simulation using overset grid

Simulation of the New Type of Carbon Fibre Grid Structures

Combination of Advanced Actuator Line/Disk Model and High-Order Unstructured Finite Volume Solver for Helicopter Rotors

A Hybrid Implicit Scheme For Solving Navier-Stokes Equations

Study of Partial Cavitation on a Plane-Convex Hydrofoil with Mesh Development by Using GMSH Free Software

Numerical Simulation on the Inviscid Flowfield of Transonic Hovering Rotor Using Implicit Method and WENO Schemes

Numerical Simulation for Transonic Flows at High Incidence Around a Complete Fighter with Two-Equation K-G Model