Abstract:This study conducted Detached-Eddy Simulations (DES) of actively controlled flow over a 0.35 m chord NACA0015 airfoil at an incidence angle of 11° and a chord Reynolds number of 1 million. The uncontrolled, natural flow were simulated by using DES-type methods, with a comparison of different underlying RANS models and subgrid-scale stress models in LES mode. Results from these computations were compared with experimental observations, enabling their reliable assessment through the detailed investigation of the Reynolds stresses as well as the separation and reattachment. It was found that among all five DES-type methods, only the Spalart–Allmaras-based Improved Delayed DES (IDDES-SA) captured the separation point as measured in the experiments. The classical vortex-shedding and the shear-layer flapping modes for airfoil flows with shallow separation were also extracted from the IDDES-SA results by using Dynamic Mode Decomposition. With better understanding of unsteady flow features, effective control practices were illustrated. The pulsed blowing actuation was adopted according to the experimental settings. The flow-field around jet orifices was resolved, instead of the use of actuation boundary conditions. It was found that for all actuation frequencies investigated in this article, the saturation of lift-to-drag ratio was yielded already at intermediate momentum coefficients, two-fifths of the actuation amplitude used in the experiment; the optimal actuation frequency was 0.6 among all cases, consistent with the dominant frequency of the baseline flow. The suppression of separation bubble led to a maximum lift-to-drag ratio enhancement of 194%, as well as a sharp decrease of all Reynolds stress components. To further reduce the strong unsteadiness introduced by excitation, a phase shift among jet orifices was applied and evaluated. The pulsed blowing with the jet orifices in an anti-phased manner was found to be very effective to damp the fluctuations of the lift around its mean value, though it led to a small decrease in mean lift.

F-16XL Hybrid Reynolds-Averaged Navier-Stokes/Large Eddy Simulation on Unstructured Grids

Constrained Large-Eddy Simulation for Aerodynamics

Constrained Large-Eddy Simulation and Detached Eddy Simulation of Flow Past a Commercial Aircraft at 14 Degrees Angle of Attack

DDES Study of Confined and Unconfined NACA Wing Sections Using Spectral Elements

Study of Delayed-Detached Eddy Simulation with Weakly Nonlinear Turbulence Model

Wall-Modeled Large-Eddy Simulation Method for Unstructured-Grid Navier–Stokes Solvers

Study of Transonic Separated Flows with zonal-DES Based on Weakly Non-linear Turbulence Model

Detached-eddy simulation of the vortex system on the high-lift common research model

A Comparative Study of DES Type Methods for Mild Flow Separation Prediction on a NACA0015 Airfoil

Numerical Study of Iced Airfoils with Horn Features Using Large-Eddy Simulation

Simulations of Complex Turbulent Flows with RANS-LES Hybrid Approaches

Detached-Eddy Simulation of Flow Past Tandem Cylinders

Numerical Investigations Of The Jaxa High-Lift Configuration Standard Model With Mflow Solver

A critical assessment of Navier–Stokes and lattice Boltzmann frameworks applied to high-lift configuration through a multiresolution approach

Numerical Simulation of Circulation Control for a Wing Section Using Coanda Jets

Sensitivities of Free-Air RANS and DDES Methods on the High-Lift NASA CRM

Towards adaptive simulations of turbulent wings at high Reynolds numbers

Detached-eddy Simulation of Flow Past a Pitching NACA 0015 Airfoil with Pulsed Actuation

DDES with Adaptive Coefficient for Stalled Flows Past a Wind Turbine Airfoil

Enhanced Prediction of Three-dimensional Finite Iced Wing Separated Flow Near Stall

Hybrid RANS/LES Capabilities of the Flow Solver FLOWer—Application to Flow Around Wind Turbines