Abstract:This study conducted Detached-Eddy Simulations (DES) of actively controlled flow over a 0.35 m chord NACA0015 airfoil at an incidence angle of 11° and a chord Reynolds number of 1 million. The uncontrolled, natural flow were simulated by using DES-type methods, with a comparison of different underlying RANS models and subgrid-scale stress models in LES mode. Results from these computations were compared with experimental observations, enabling their reliable assessment through the detailed investigation of the Reynolds stresses as well as the separation and reattachment. It was found that among all five DES-type methods, only the Spalart–Allmaras-based Improved Delayed DES (IDDES-SA) captured the separation point as measured in the experiments. The classical vortex-shedding and the shear-layer flapping modes for airfoil flows with shallow separation were also extracted from the IDDES-SA results by using Dynamic Mode Decomposition. With better understanding of unsteady flow features, effective control practices were illustrated. The pulsed blowing actuation was adopted according to the experimental settings. The flow-field around jet orifices was resolved, instead of the use of actuation boundary conditions. It was found that for all actuation frequencies investigated in this article, the saturation of lift-to-drag ratio was yielded already at intermediate momentum coefficients, two-fifths of the actuation amplitude used in the experiment; the optimal actuation frequency was 0.6 among all cases, consistent with the dominant frequency of the baseline flow. The suppression of separation bubble led to a maximum lift-to-drag ratio enhancement of 194%, as well as a sharp decrease of all Reynolds stress components. To further reduce the strong unsteadiness introduced by excitation, a phase shift among jet orifices was applied and evaluated. The pulsed blowing with the jet orifices in an anti-phased manner was found to be very effective to damp the fluctuations of the lift around its mean value, though it led to a small decrease in mean lift.

A Comparative Study of DES Type Methods for Mild Flow Separation Prediction on a NACA0015 Airfoil

Les and Cdns Investigation of T106c Low Pressure Turbine

Constrained Large-Eddy Simulation and Detached Eddy Simulation of Flow Past a Commercial Aircraft at 14 Degrees Angle of Attack

Effects of Micro Blowing/suction Flow Control Devices on a NACA0015 Airfoil

IDDES Method Based on Differential Reynolds-stress Model and Its Application in Bluff Body Turbulent Flows

Numerical Investigation of Massively Separated Flows Past RLG Using Advanced DES Approaches

Detached-eddy Simulation of Flow Past a Pitching NACA 0015 Airfoil with Pulsed Actuation

DDES with Adaptive Coefficient for Stalled Flows Past a Wind Turbine Airfoil

Enhanced Prediction of Three-dimensional Finite Iced Wing Separated Flow Near Stall

NUMERICAL PREDICTION OF MASSIVE SEPARATION AND UNSTEADY FLOWS AROUND BLUFF-BODIES

Numerical Studies of Undulation Control on Dynamic Stall for Reverse Flows

Performance Of A Modified Ddes For The Near Stall Flow Past A Naca0015 Airfoil

Wake dynamics of low-Reynolds-number flow around a two-dimensional airfoil

Study of Transonic Separated Flows with zonal-DES Based on Weakly Non-linear Turbulence Model

DETACHED EDDY SIMULATION FOR THE COMPRESSOR STATOR OF HIGH-PRESSURE CASCADE WITH MASSIVE SEPARATION

Application of Delayed Detached Eddy Simulation and RANS to Compressor Cascade Flow

Detached-eddy simulation of the vortex system on the high-lift common research model

Computation of Several Turbulent Flows with the Des-Sa Model

Simulations of Transition and Separation Past a Wind-Turbine Airfoil Near Stall

Numerical Prediction of Massive Separation Unsteady Flows Around Bluff-Bodies

Numerical study of passive and active flow separation control over a NACA0012 airfoil