Abstract:Purpose - This paper aims to introduce a series of experimental results which are the extension of our previous novel observations (Xie et al., Soft Matter, 2011), which could be helpful for revealing the lubrication failure mechanism in bearings when they are exposed to an electrical environment.Design/methodology/approach - An experimental apparatus where a ball was in contact with a glass disk coated with a semi-reflective chromium layer. A small volume of oil droplet was put into the microgap of the ball-disk contact. Then, a potential was applied onto the oil micropool formed by the droplet surrounding the contact region.Findings - It has been found that destabilization of the low-conducting oil micropool around the contact region could be induced after applying a potential. Thin oil films could be drained out of the oil pool and spread on the tribopair surfaces, resulting in the depletion of the oil pool. When the applied potential was increased, the occurrence of spreading would be easier and its development would be more obvious. In contrast, the electrospreading behavior would be suppressed when the oil viscosity, contact load and oil pool size were increased. Thermocapillary force due to thermal effect as a result of the current flow near the oil pool border has been proposed as the main driving force for the spreading behavior. The influences of the operating parameters have been ascribed to the change of the electric current near the oil pool border as well as the corresponding variations in the temperature rise and the surface tension of the oil pool.Originality/value - This is the first study to directly observe that the lubricant oil micropool around the contact region could deplete after applying a potential, potentially resulting in oil starvation in the contact region.

Experimental Investigation of Migration Characteristics of Lubricants under Minimum Lubricant Supply Conditions

Experimental investigation of lubricant flow properties under micro oil supply condition

Experimental Investigation of Centrifugal Effects on Lubricant Replenishment in the Starved Regime at High Speeds

Experimental Investigation of Lubrication Film Starvation of Polyalphaolefin Oil at High Speeds

Experimental Investigation of the Oil Supply Layer in a Model Rolling Bearing

Experimental Investigation of Lubrication Properties at High Contact Pressure

An Experimental-Study on Oil-Supply in A Space Bearing with an Oil-Impregnated Retainer

Destabilization of Lubrication Oil Micropool under Charged Conditions

Experimental Study on Molecular Arrangement of Nanoscale Lubricant Films—a Review

Fluorescence in Situ Observation of the Interfacial Dynamics and Adhesion Behaviors of Water and Oil Droplets in A Confined Geometry

Experimental research of sliding friction coefficient of rough surface under lubricated point contact

Experimental Study of the Interfacial Slip on Hydrodynamic Lubrication Under Different Wettabilities

Theoretical and Experimental Investigation on Local Turbulence Effect on Mixed-Lubrication Journal Bearing During Speeding Up

Influence of the cage on the migration and distribution of lubricating oil inside a ball bearing

Experimental Study of Lubricant Distribution and Lubrication Enhancement Induced by Ball Bearing Cage

Numerical simulations of lubricated contact - Effects of variation of entraining velocity

Experimental Investigation of Lubrication Failure of Polyalphaolefin Oil Film at High Slide/Roll Ratios

Analysis of Oil-Air Two-Phase Flow Characteristics inside a Ball Bearing with Under-Race Lubrication

In Situ Measurement of Oil Reservoir and Oil Layers by Fluorescence Technique in a Ball-on-Disc Test Rig

The investigation of contact ratio in mixed lubrication

Film Thickness Decay and Replenishment in Point Contact Lubricated with Different Greases: A Study into Oil Bleeding and the Evolution of Lubricant Reservoir