Abstract:The operation of sections of main gas pipelines that are on the verge of developing a design resource is associated with a number of problems in ensuring industrial safety. One of the most acute problems is the occurrence of local defects. The main material for the manufacture of main gas pipelines is steel. During the operation of the pipeline, local defects occur due to metal corrosion or mechanical damage to the gas pipe. Such concentrators with high internal pressure in the gas pipeline can lead to the destruction of the entire structure. In this case, the situation of destruction is especially critical, since it can cause a man-made disaster. To increase the shelf life of damaged sections of main pipelines in places where defects are located, banding with composite linings is used. The article contains part of a comprehensive study, which consisted in the development of methods for modeling the main gas pipeline for oil and petroleum products under seismic loads, dynamic stress-strain state under the influence of seismic loads and stress-strain state of a damaged gas pipeline reinforced with composite linings under the action of internal pressure. The technology of manufacturing linings from composite material is also described in detail. At the same time, a geometric model of the section of the main gas pipeline with composite linings was developed and an analysis of the loading of the section of the main gas pipeline in ANSYS was carried out, provided that the lining is mounted without tension on the pipeline and provided that the lining is mounted with tension, where a comparative analysis showed that the installation condition of composite linings does not significantly affect the static stress state.

Experimental Research and Numerical Simulation on Static Deformation of Gasbag with Textile Reinforced Composite Lining

Numerical Simulation of Whole Process and States of Tensile Membrane Structure

Numerical analysis and experimental study on deployment process of coil-folded inflatable tube

Experiment and finite element analysis on pressure distention of laser welding dimple jacket

Analysis and Evaluation of Strengthening Effect of Inflatable Rings on Soft Stratospheric Airship

Nonlinear fluid-structure interaction analysis of the compression process of inflatable tube structures

Simulation and experimental verification on fluid-structure interaction of T-shaped pressure pipeline

Experimental and Numerical Study of the Static Performance of a Hoop-Wrapped CNG Composite Cylinder Considering Its Variable Wall Thickness and Polymer Liner

DEVELOPMENT OF LOADING MODELS AND ANALYSIS OF THE STRESS-STRAIN STATE OF THE MAIN GAS PIPELINE WITH COMPOSITE LININGS

Research on Mechanics of Ship-Launching Airbags I-Material Constitutive Relations by Numerical and Experimental Approaches

Modelling and simulation of a sandwiched tube-type airbag and its optimization using design of experiments

Experimental Study of Water Tank under Impulsive Loading

Test Study and Numerical Simulation of Deflation Process of an Air-Supported Membrane Structure

Dynamic Response of Pressurized Gas Pipes Subjected to Transverse Impact Loads

Design and performance study on adaptive sealing of a dry cabin for maintenance of submarine pipeline

Strength Analysis and Influence Factors Research of Carbon-Fiber Wound Composite Gas Cylinder With Aluminum Liner

Structural Performance of Water Tank under Static and Dynamic Pressure Loading

Research on Computer Simulation of Large Cubage Airbag

Experimental Study of Inflatable Deployment Process of Folded Membrane Tubes

Strength and Failure Analysis of Fiber-Wound Composite Gas Cylinder via Numerical Simulation

Effect of Pressure Difference between Inner and Outer Gas Layer on Micro-Tube Deformation during Gas-Assisted Extrusion