Abstract:Amorphous hydrous ruthenium oxide/active carbon (RuO2. xH(2)O/C) powders were prepared by a simple procedure based on the sol-gel process. The precursor was obtained by mixing an aqueous solution of RuCl3 and active carbon powders at pH 7. When annealing the precursor at 150 degreesC for 7-9.5 h, the RuO2. xH(2)O/C powders obtained had the highest specific capacitance. Transmission electron microscopy photographs showed that the RuO2. xH(2)O primary particles were about 10-15 nm diam. They adhered to form large porous secondary particles. A modeling capacitor was made with electrodes comprised of RuO2. xH(2)O/C powder and 30% H2SO4 electrolyte. At 10-20 wt % ruthenium in the electrodes, the specific capacitance remained almost unchanged at 243 F/g, which included both the electric double-layer capacitance associated with the high surface area of active carbon and redox capacitance associated with ruthenium oxide. About 52% of the RuO2 in the RuO2. xH(2)O/C powders was utilized. More than 50% of the capacitance in the electrode with 12.1% ruthenium was due to the formation of the double layer, but for the electrode with 21.1% ruthenium, the capacitance attributed to the double layer dropped to 16.8% of the total capacitance. When the electrodes contained ruthenium from 35 wt % to pure RuO2. xH(2)O, the specific capacitance increased from 350 to 715 F/g. The specific capacitance was proportional to the mass of the ruthenium in the electrodes. This enabled the specific capacitance to be controlled by changing the mass ratio of RuCl3 to active carbon in the preparation. Physical properties of the material and electrochemical characteristics of electrodes are also reported along with the capacitor performance. (C) 2001 The Electrochemical Society.

Fabrication and properties of a new type micro super-capacitor

Zeolitic Imidazolate Framework Derived ZnCo2O4 Hollow Tubular Nanofibers for Long-Life Supercapacitors

Design and fabrication of a RuO2 microelectrode-based micro-supercapacitor

Monocrystalline FeMnO3 on Carbon Cloth for Extremely High-Areal-Capacitance Supercapacitors

Boosting Supercapacitive Performance of Flexible Carbon Via Surface Engineering.

A High-Performance Three-Dimensional Micro Supercapacitor Based on Ripple-Like Ruthenium Oxide–carbon Nanotube Composite Films

Fabrication of a Symmetric Micro Supercapacitor Based on Tubular Ruthenium Oxide on Silicon 3D Microstructures

High-performance supercapacitors based on nanocomposites of Nb 2O 5 nanocrystals and carbon nanotubes

Ultrahigh power graphene based supercapacitor

Supercapacitors based on electrospun metal oxide nanofibers

A High-Performance Asymmetric Supercapacitor Based on Vanadyl Phosphate/carbon Nanocomposites and Polypyrrole-Derived Carbon Nanowires

Activated Carbon Based Ruthenium Oxide Materials For Supercapacitor

Optimizing Fe2O3-based supercapacitor cathode with tunable surface pseudocapacitance via facile in situ vulcanization process

Fabric- and film-structured supercapacitor

Hydrous Ruthenium Oxide with High Rate Pseudo-Capacitance Prepared by a New Sol-Gel Process

Electrochemical Performance of Nickel Oxide/Koh/Active Carbon Super-Capacitor

Fabrication of bismuth ferrite/graphitic carbon nitride/N-doped graphene quantum dots composite for high performance supercapacitors

Preparation And Electrochemistry Of Hydrous Ruthenium Oxide/Active Carbon Electrode Materials For Supercapacitor

Hydrous–ruthenium–oxide thin film electrodes prepared by cathodic electrodeposition for supercapacitors

Fabrication of a novel micro-supercapacitor for MEMS and its performance analysis

Simultaneous synthesis of UiO-66/ZrO 2 composites for high-performance supercapacitors: Fabrication, characterization, and electrochemical evaluation