Abstract:A novel fiber-optic refractive index (RI) sensor based on a splicing point tapered fiber Michelson interferometer is proposed. It consists of a short section of thin-core fiber (TCF), which is spliced to a standard single-mode fiber, then the fused region is drawn into a taper by using residual heat. The interference between the core and cladding modes in the TCF is utilized, which is insensitive to variations in the RI of the surrounding environment but susceptible to external temperature changes. However, owing to the Fresnel reflection on the fiber end face, the intensity of the reflection spectrum decreases with increasing RI of the surrounding environment. Thus, the RI and temperature can be demodulated by the intensity and wavelength of the reflection spectrum, respectively, which can eliminate the crosstalk between RI and temperature. We experimentally found that the sensor has RI sensitivity of up to 68.60 dB/RIU for a TCF length of 10 mm and a waist diameter of 50 mu m. The temperature characteristics of the sensor in the range of 30 to 90 degrees C were also investigated, and a sensitivity of about 57 pm/degrees C was obtained. Moreover, the compact size, easy fabrication, and low cost of the proposed fiber-optic RI sensor make it an attractive device.

Bent optical fiber taper for refractive index detection with a high sensitivity

Fiber-Optic Refractive Index Sensor via Macro-Bending Tapered Waveguide

High Sensitivity Refractometer Based on Tapering Two-Mode Fiber Embedded Long-Period Fiber Grating

Refractive Index Sensing Based on Mach-Zehnder Interferometer Formed by Three Cascaded Single-Mode Fiber Tapers

Slight-Offset Tapered Multimode Fiber with High Sensitivity for Low Refractive Index Range

High Sensitive Refractive Index Sensor Based on Dispersion Turning Point Long-Period Fiber Gratings in Tapered Fiber

Refractive Index Sensor Based on Tilted Fiber Bragg Grating and Stimulated Brillouin Scattering.

A Sensitivity-Enhanced Refractive Index Sensor Using A Single-Mode Thin-Core Fiber Incorporating an Abrupt Taper

Investigation of a Macro-Bending Tapered Plastic Optical Fiber for Refractive Index Sensing

High sensitivity refractive index sensor based on tilted fiber Bragg gratings

Modal Interferometer Based on A C-Shaped Ultrathin Fiber Taper for High-Sensitivity Refractive Index Measurement

Improvement on Refractive Index Sensing by Exploiting the Tapered Two-Mode Fibers

S-Tapered Fiber Sensors for Highly Sensitive Measurement of Refractive Index and Axial Strain

Balloon-like Singlemode-Tapered Multimode-Singlemode Fiber Structure for Refractive Index Sensing

Highly Improved Refractive Index Sensitivity in Fiber Mach-Zehnder Interferometer Based on Two Tapers

Improved optical fiber Mach-Zehnder high-sensitivity refractive index sensor

Sensitivity-enhanced Refractive Index Sensor by Using Tapered Thin-Core Fiber Based Inline Mach-Zehnder Interferometer

Novel Intensity-demodulated Fiber-optic Refractive Index Sensor Based on Splicing Point Tapered Fiber

Refractive index sensors based on the fused tapered special multi-mode fiber

Ultra-Sensitive Refractive Index Sensor with Slightly Tapered Photonic Crystal Fiber

High Sensitivity Refractive Index Sensor based on a Tapered Single-mode-Multimode-Single-mode Fiber Structure