Abstract:<p>For wear resistant steels, there is generally a linear relationship between the initial hardness and wear resistance, yet a high initial hardness limits the formability of components. The intrinsic ductility of austenite and strain hardening produced from the transformation-induced plasticity (TRIP) effect during service opens a new window for this contradiction. Herein, the wear resistance and the corresponding failure mechanisms of 5Mn steels after different heat treatment processes were evaluated using a ball-on-disk sliding test under dry conditions. The wear behaviors of the counterbodies were also studied to elucidate the wear mechanism of the tribo-system. The results show that the microstructures of the hot-rolled and air-cooled steel mainly comprised martensite. When the intercritical annealing temperature was relatively low (<695°C), the microstructure primarily consisted of reversed austenite and ferrite. The samples annealed at 630°C, 645°C, 660°C, and 675°C had a similar initial hardness, while the sample annealed at 675°C possessed a wear resistance that was 3.25 times that of the steel annealed at 630°C. The large difference in the wear resistance was predominately due to the gradient of strain hardening provided by the varied amount and mechanical stability of the retained austenite. The transformation from austenite to martensite, which has an increased hardness, improves the work hardening. A strengthening layer formed with a certain thickness that provided stress support during the wear process and enhanced the wear resistance. When the annealing temperature reached 695°C, a large amount of secondary martensite was generated from austenite that had a low thermal stability, which improved the initial hardness and wear resistance. The steels with a large amount of martensite had an enhanced wear resistance, but the elongation severely deteriorated, leading to unsatisfactory formability. The present work provides guidance for designing novel steels with an excellent balance of good formability and decent wear resistance by precisely adjusting the characteristics of the retained austenite.</p>

Micro-characterization of macro-sliding wear for steel

Wear Behaviour and Microstructural Changes of SiCw-Al Composite under Unlubricated Sliding Friction

Numerical Investigation of the Evolution of Grit Fracture and Its Impact on Cutting Performance in Single Grit Grinding

Wear Rate, Frictional Temperature, and Energy Consumption of Steel 52100 with Different Microstructures During Sliding

Sliding abrasive wear characteristics of steels with different hardness

Micro- and Nanowear of Self-Mated Steel Generated and Studied With an AFM at the Single Asperity Level

New insight into the dry rolling-sliding wear mechanism of carbide-free bainitic and pearlitic steel

Microstructure Evolution and Fretting Wear Mechanisms of Steels Undergoing Oscillatory Sliding Contact in Dry Atmosphere

Sliding wear of medium-carbon bainitic/martensitic/austenitic steel treated by short-term low-temperature austempering

Asperity level characterization of abrasive wear using atomic force microscopy

A Study On The Dynamic Characteristics Of Abrasion For High-Chromium Alloys

Wear Property and Wear Mechanisms of High-Manganese Austenitic Hadfield Steel in Dry Reciprocal Sliding

Surface self-nanocrystallization and -lubricating dependent wear resistance of austenitic steels at same initial hardness level

Influence mechanism of grinding surface quality of 20CrMnTi steel on contact failure

Atomistic insights into friction and wear characteristics of M50 bearing steel: a molecular dynamics simulation study

A study of the abrasive wear of carbon steels

Sliding wear resistance of Fe–30Mn–8Al–1.2C steel modulated by κ–carbide

Friction coefficient and wear mode transition in micro-scale abrasion tests

Mechanisms of near-surface structural evolution in nanocrystalline materials during sliding contact

Unraveling the significant role of retained austenite on the dry sliding wear behavior of medium manganese steel

Effect of slippage rate on frictional wear behaviors of high-speed steel with dual-scale tungsten carbides (M6C) under high-pressure sliding-rolling condition