Fire Resistance Behavior and Mechanism of Concrete-Filled Square Hollow Columns in Non-Uniform Fires

吕学涛,杨华,张素梅

DOI: https://doi.org/10.14006/j.jzjgxb.2013.03.019

2013-01-01

Abstract:The typical cross-sectional temperature distribution of concrete-filled squre hollow sections(SHS) in single surface,opposite-two-surface,three-surface and four-surface fires was investigated in this research.The axial deformation and mid-height deflection versus time curves were analyzed respectively,to clarify the mechanism of the columns in different fire conditions and the influence of the fire boundary conditions.Conclusions can be draw from the theoretical analysis results.For concrete-filled SHS columns subjected to opposite-two-surface and four surface fires,the thermal distribution is axially symmetric,inducing dual-axisymmetrical temperature strains and temperature stresses.The mechanisms of the columns are similar to the condition in room temperature.While being exposed to one-surface or three-surface fires,the columns have monosymmetric temperature distribution,which causes load eccentricities and the mechanism of the columns different from those in room temperature.The column bends towards the exposed side first,then the opposite direction.Compared with the non-uniform temperature deformation and load eccentricity,which are caused by non-uniform temperature gradients,the number of surfaces exposing to fire is the key factor that influences the fire resistance of concrete-filled SHS columns.Thus in most cases,the fire resistances are increasing in turn from four-surface,three-surface and opposite-two-surface to single surface fire.However,in some special cases,for instance when the slenderness ratio λ30,the fire resistances of composite columns are smaller in three-surface fire than those in four-surface fire.The potentional danger therefore should be induced if using the current related codes,which are based on four-surface fire condition.