Abstract:The dye‐sensitized solar cells (DSSCs) can be effectively improved and stabilized by outstanding electrical and morphological characteristics of TiO2 nanofibres combined with bio‐calcium doping. The pristine and bio‐Ca‐doped TiO2 nanofibres were fabricated using a cost‐effective electrospinning technique. Biocompatible calcium carbonate nanoparticles (bio‐Ca) were synthesized from the cuttlebone of Sepia Pharaonis. Summary The dye‐sensitized solar cells (DSSCs) can be effectively improved and stabilized by outstanding electrical and morphological characteristics of TiO2 nanofibres combined with bio‐calcium doping. The pristine and bio‐Ca‐doped TiO2 nanofibres were fabricated using a cost‐effective electrospinning technique. Biocompatible calcium carbonate nanoparticles (bio‐Ca) were synthesized from the cuttlebone of Sepia Pharaonis. Moreover, a facile one‐step procedure was employed to fabricate efficient TiO2 nanofibres‐based DSSCs using a Pechini‐type sol. This approach produced a highly porous dense film of TiO2 upon sintering without the need for the hot‐pressing or adhesion layer steps. Based on the results, the DSSCs fabricated by the bio‐Ca‐doped TiO2 nanofibres showed the highest Isc , Voc , and η of 2.19 mA, 0.41 V, and 1.48% respectively. This superiority could be due to the higher specific surface area and the relatively smaller average diameter observed for bio‐Ca‐doped TiO2 nanofibres, which improved dye‐loading and guided electron transport respectively. In addition, Ca2+ doping significantly suppressed the photocatalytic activity in the bio‐Ca‐doped TiO2 nanofibres owing to the formation of the TiO2 rutile‐anatase combined phase. Besides, the substitution of Ti4+ with Ca2+ positively affects the conduction band of TiO2 and causes trap sites that retard the charge recombination. Our results also demonstrated that the bio‐Ca‐doped TiO2 nanofibres‐based DSSC maintained about 78.38% of its initial efficiency after two weeks, while DSSCs fabricated by the TiO2 nanofibres and TiO2 nanoparticles retained 63.71% and 27.38% respectively. The superior stability could be due to the combined effect of nanoparticles into nanofibres transformation and bio‐Ca doping.

Enhanced conversion efficiency of dye-sensitized titanium dioxide solar cells by Ca-doping

Improved Performance of Dye Sensitized Solar Cells Using Cu-doped TiO2 As Photoanode Materials: Band Edge Movement Study by Spectroelectrochemistry

Enhanced Performance of Dye-Sensitized Solar Cells with Layered Structure Graphitic Carbon Nitride and Reduced Graphene Oxide Modified TiO2 Photoanodes

Carbon-doped Titanum Dioxide Nanocrystals for Highly Efficient Dye-Sensitized Solar Cells

Improved photovoltaic performance of dye-sensitized solar cells (DSSCs) by Zn + Mg co-doped TiO2 electrode

Electronic-Insulating Coating of Caco3 on Tio2 Electrode in Dye-Sensitized Solar Cells: Improvement of Electron Lifetime and Efficiency

Chemically modified titanium oxide nanostructures for dye-sensitized solar cells

Effect of Cerium Doping in the TiO2 Photoanode on the Electron Transport of Dye-Sensitized Solar Cells

Promotion of Charge Transport in Low-Temperature Fabricated TiO2 Electrodes by Curing-Induced Compression Stress

Zinc-doping in TiO 2 films to enhance photovoltaic performance of Dye-sensitized solar cells

Increasing the Oxygen Vacancy Density on the Tio2 Surface by La-Doping for Dye-Sensitized Solar Cells

Engineering the Electronic Structure towards Visible Lights Photocatalysis of CaTiO 3 Perovskites by Cation (La/Ce)-Anion (N/S) Co-Doping: A First-Principles Study.

Engineering the Electronic Structure towards Visible Lights Photocatalysis of CaTiO3 Perovskites by Cation (La/Ce)-Anion (N/S) Co-Doping: A First-Principles Study

Modification Of Tio2 Electrode With A Series Of Alkaline-Earth Carbonates: Performance Improvement Of Quasi-Solid-State Dye-Sensitized Solar Cells

Engineering the Electronic Structure towards Visible Lights Photocatalysis of CaTiO<sub>3</sub> Perovskites by Cation (La/Ce)-Anion (N/S) Co-Doping: A First-Principles Study

Charge Recombination and Band-Edge Shift in the Dye-Sensitized Mg2+-Doped TiO2 Solar Cells

Zinc-Doping in TiO<sub>2 </sub>Films to Enhance Photovoltaic Performance of Dye-Sensitized Solar Cells

BaCO3 Modification of TiO2 Electrodes in Quasi-Solid-State Dye-Sensitized Solar Cells: Performance Improvement and Possible Mechanism

Efficiency and stability improvement of natural dye‐sensitized solar cells using the electrospun composite of TiO2 nanofibres doped by the bio‐Ca nanoparticles

Improved photovoltaic performance of dye-sensitized solar cells by Sb-doped TiO2 photoanode

Mesoporous (N, S)-codoped TiO2 nanoparticles as effective photoanode for dye-sensitized solar cells