Abstract:Dynamic analysis is of great importance not only for understanding the natural characteristics and dynamic response of a rotor-bearing system, but also for supplying knowledge of the fault mechanism. The dynamic analysis of a large-scale water-turbine generator set has rarely been investigated. This article establishes a model of a large water-turbine generator set and presents some research results. This article provides a detailed calculation of the critical speed and vibration modes by the Riccati transfer matrix method (RTMM) to study the influence of stiffness of the guide bearings on the characteristics of the shaft. A detailed dynamic model is presented of the No. I unit of the Guangzhou Pumped Storage Power Station (GPSPS) in southern China, including nonlinear characteristics of the guide bearing, the thrust bearing, and the magnetic force. An efficient simulation method, referred to as the transient Riccati transfer matrix method (TRTMM), is used to calculate the transient response of the rotor-bearing shaft system. Sonic simulation results are also presented for responses to other types of forces such as unbalance inertial forces and nonlinear magnetic forces. Results show that, for large vertical water-turbine generator sets, there exists a common characteristic in the first three vibration modes, that is, the maximum amplitude is at the generator rotor in the first vibration mode, while in the third vibration mode, the maximum amplitude is near the turbine runner. Simulation results show that the method and program are correct and can be used expediently. The response of the rotor-bearing system with different values of preload coefficients of the tilting-pad journal bearing reflects the influence of the bearing clearance on the vibration amplitude and the time required for the vibration from transient state to steady state. The effect of hydraulic forces acting on the runner shows that the vibration amplitude and the time required for the vibration at the three guide bearings to reach steady state are different. The analysis of the lateral shaft vibration caused by nonlinear magnetic forces shows that it will produce a new frequency component of 150 Hz.

Analysis of High On-Line Vibration Measurement of Nuclear Power Half-Speed Turbo-Generator

On-line Measurement for Power Angle and Circuit Parameter in the Turbo Steam Generator with the FEM Based

Analysis of Vibration Monitoring Data of an Onshore Wind Turbine under Different Operational Conditions

Time-frequency Analysis on Torsional Vibration of Turbo-generator Shafts

Signal Analysis on Flexural and Torsional Vibration of Generator Shafts Impacted by Subsynchronous Resonance

Analysis of Flexural and Torsional Vibration for Turbogenerator Shafts on Power Impact

Online Identification Methodology of Field Winding Short Circuit Fault of Turbogenerator

Online Monitoring of Inter-turn Short Circuit Fault of Field Winding in Large Turbo-generator

Design of On-line Vibration Monitoring System for Turbine

Evaluation of Influences of Large Disturbances in Power Systems on the Shaft Torsional Oscillations of the Million-kilowatts-class Half-speed Nuclear Turbogenerator

Mechanical fault diagnosis for abnormal vibration excited by steam in high pressure turbine of turbo-generator set

STUDY ON METHODS OF VIBRATION FAULT DIAGNOSIS BASED ON TIME-FREQUENCE CONTOUR MAP FOR TURBINE GENERATOR UNIT

The Vibration and Dynamic Balancing at Site of Homemade 60Hz Steam Turbine Set

Vibration Failures Due to the Non-uniform Thermal Deformation Diagnosed by the Use of Hologram Spectral Techniques

APPLICATION OF WAVELETS TO TURBOGENARATOR UNIT FOR IMPACE FAULT DETECTION

Vibration Analysis of the Multi-Unit Permanent Magnet Synchronous Machine in the Non-Mechanical-load Indirect-Testing Situation

Vibration Analysis and Suppression of Megawatt Permanent Magnet Generator

Torsional and lateral vibration analysis of wind turbine generator bearing outer ring fault considering unbalanced magnetic pull

NONSYNCHRONOUS VIBRATION OF THE ACTIVE MAGNETIC BEARINGS-ROTOR SYSTEM IN THE HIGH TEMPERATURE GAS-COOLED REACTOR

Monitoring and Analyzing Torsional Vibration of Diesel Engine's Shaft System Based on 3D Graphic Spectrum

DYNAMIC ANALYSIS OF A HYDRAULIC TURBINE UNIT*