Abstract:Abstract According to the report published by the International Energy Agency (IEA), active space cooling and air conditioning systems consume approximately 16% of the building sector’s final electricity consumption and contribute 3.94% of global greenhouse gas emissions. In this regard, the use of low-cost but effective passive solutions, such as organic phase change materials (PCM) on the building envelope, can provide high thermal mass and thus can lower the temperature fluctuation inside the building. In the current study, the potential of PCM-enhanced building envelopes to enhance thermal comfort has been studied. The study has been performed using the conduction finite difference (ConFD) algorithm in EnergyPlus software. A comparative study has been done for a traditional reinforced cement concrete (RCC) reference test room of size (5m x 6m x 3m) and another room of the same size with PCM-enhanced walls for the hot and humid climate zone of Guwahati (latitude 26.1, longitude 91.7), in India. A PCM thickness of 20 mm is used at the external surface of the wall between the red clay burnt brick (120 mm in thickness) and the cement plaster (25mm thick). The PCM used for the study is a biocomposite PCM, named WH-PCM, with a melting point of 31.5°C and thermal conductivity of 0.27 W/mK. The simulation results reveal that the R-value of the external wall of the room with PCM walls has been increased by 84.90% compared to the reference room with the incorporation of WH-PCM, resulting in a mean zone temperature difference of 0.3°C throughout the year. Also, the indoor thermal discomfort hours have been annually reduced by 15.82% with the use of WH-PCM when compared with the reference room. A similar temperature difference trend, which is 1.93°C, is also observed in the single PCM brick experimental result under identical testing conditions as a regular brick of the same size.

Experimental and Numerical Study of the Thermal Performance of a New Type of Phase Change Material Room

Thermal Performance of a New Type of Phase Change Material Room in Summer and Winter

Study of the Thermal Behavior of the Composite Phase Change Material (PCM) Room in Summer and Winter

Experimental study of the thermal and energy conservation characteristics of combined phase change material (PCM) room in summer

Experiment Study on Thermal Performance of Building Integrated with Double Layers Shape-Stabilized Phase Change Material Wallboard

Experimental Research on Summer Heat Exchange Performance of Combined Phase Change Material Envelops

Thermal Performance Analysis of Lightweight Phase Change Envelopes

Numerical Study on the Thermal Performance of Building Wall and Roof Incorporating Phase Change Material Panel for Passive Cooling Application

Experimental Research on Thermal Performance of Shape-Stabilized Phase Change Material Floor

Numerical Study of the Thermal Performance of the PCM Wall under Periodical Outside Temperature Waves

Experimental research on the use of phase change materials in perforated brick rooms for cooling storage

Experimental Study on the Heat Transfer Characteristics of Different Walls with Phase Change Materials in Summer

Experimental Investigation and Numerical Modeling of Room Temperature Control in Buildings by the Implementation of Phase Change Material in the Roof

Enhancing thermal comfort in buildings through the integration of phase change material on the building envelope: a simulation study

Thermal Performance Analysis of PCM Wallboards for Building Application Based on Numerical Simulation

Experimental Study on Thermal Performance Improvement of Building Envelopes by Integrating with Phase Change Material in an Intermittently Heated Room

Experimental study on the performance of a novel RC-PCM-wall

Experimental Assessment on the Use of Phase Change Materials (Pcms)-Bricks in the Exterior Wall of a Full-Scale Room

Experimental Study on the Thermal Performance of the Shape-Stabilized Phase Change Material Floor Used in Passive Solar Buildings

Experimental Thermal Performance of Wallboard with Hybrid Microencapsulated Phase Change Materials for Building Application

Thermal Performance of Phase Change Material Wallboard with Typical Structure: Artificial Controlled Condition Experimental Investigation