Abstract:This article presents an 18 similar to 30 GHz vector-sum phase shifter for wireless application in the millimeter-wave regime. It is composed of an I/Q signal generator, two variable-gain amplifiers (VGA), and a digital-to-analog converter with a quadrant selector. To attain wideband quadrature signal, a two-stage hybrid based on transformers is proposed to realize the I/Q signal generator. The first- and second-stage hybrids are designed with different resonating frequencies. As a result, the amplitude and phase errors of the I/Q signal generator are significantly decreased in a wide frequency band. In addition, theoretical analysis based on a simplified equivalent-circuit model is performed to guide the circuit implementation, and its correctness is demonstrated by electromagnetic simulation. To mitigate the impact of the VGAs' parasitics on the phase performance, a capacitive-neutralization technique is applied to cancel parasitics of transistors in the VGAs. A prototype circuit is designed using a 130-nm SiGe BiCMOS process. The measured results show that the circuit achieves a root-mean-square (RMS) amplitude error of less than 1.4 dB and an RMS phase error of 1.4 degrees similar to 3.4 degrees across 18 similar to 32 GHz. The tested peak gains of all the phase states are -1 similar to 4.5 dB with an input balun (approximate to 1.9 dB loss) and an output balun (approximate to 2 dB loss) at 22 GHz. Also, the input 1-dB compression point and noise figure are tested, which are >=-1 dBm and <= 15.5 dB in the targeting frequency band.

A K-band CMOS Monopulse Comparator Incorporating the Phase-Invertible Variable Attenuator

A DC-32GHz 7-Bit Passive Attenuator with Capacitive Compensation Bandwidth Extension Technique in 55 Nm CMOS

Design of a Low-Insertion-phase-shift MMIC Attenuator Integrated with a Serial-to-parallel Converter

A DC-<i>Ka</i>-Band 7-Bit Passive Attenuator With Capacitive-Compensation-Based Bandwidth Extension Technique in 55-nm CMOS

Fully integrated pseudo differential K-band power amplifier in 0.13um standard CMOS

An 18 similar to 30 GHz Vector-Sum Phase Shifter With Two-Stage Transformer-Based Hybrid in 130-nm SiGe BiCMOS

A DC-28-GHz 7-Bit High-Accuracy Digital-Step Attenuator in 55-nm CMOS

An Ultra Broadband DC-40GHz 4-Bit GaAs Phemt MMIC Digital Attenuator

An E-band Subradix Active Phase Shifter with < 0.69° RMS Phase Error and 16-Db Attenuation in 28-Nm CMOS

A Novel Ultra Broadband 8-45 GHz 4-Bit GaAs Pseudomorphic High Electron Mobility Transistors (phemt) Monolithic Digital Attenuator Used for Gain Control of Transceivers

A 100–117 GHz W-Band CMOS Power Amplifier With On-Chip Adaptive Biasing

Two-Way Current-Combining -Band Power Amplifier in 65-nm CMOS

An 18~30 GHz Vector-Sum Phase Shifter with Two-Stage Transformer-Based Hybrid in 130-Nm SiGe BiCMOS

A 25-35 GHz 5-Bit Digital Attenuator with Low RMS Amplitude Error and Low Phase Variation in 65 Nm CMOS.

A CMOS High-Speed Multistage Preamplifier for Comparator Design

A Broadband Passive Monopulse Comparator Mmic

A Ku-band 180° Phase Shifter with 2-Bit Attenuation Control Based on High-pass/low-pass Network

A Dual-Mode SIW Compact Monopulse Comparator for Sum and Difference Multibeam Radar Applications

Design of a Wideband Compact CMOS Integrated Attenuator with Low Insertion Loss and High Accuracy

Design and Implementation of Wideband Monopulse Comparator Based on Inverted-Microstrip Gap Waveguide Technology

X‐Band 130‐nm CMOS Transceiver Front‐end with a Broadband Attenuator Design for Phased‐array Systems