Abstract:Silver (Ag)‐doped PbS (PbS:Ag) thin films of 616 to 745 nm in thickness were prepared on glass substrates via cost‐effective nebulizer spray method by adding different Ag levels from 2% to 8% at 200°C. For solar cell applications, the effect of Ag doping concentration on structural, morphological, optical, photoluminescence, and electrical chattels of PbS thin film has been studied. X‐ray diffraction pattern confirmed the polycrystalline behavior of the prepared PbS:Ag films with cubic crystalline nature. The crystalline size and texture coefficient were increased by increasing Ag doping concentration. From the morphological studies by scanning electron microscope (SEM) and atomic force microscope (AFM), the grain size of the films and surface roughness values were increased for the increase in Ag doping concentration. EDS spectra confirmed the existence of Ag, Pb, and S elements in the select 6% Ag‐doped PbS film. Peaks related to silver oxide started to emerge at 6% of Ag doping level. The optical direct band gap value was reduced from 1.51 to 1.17 eV for Ag doping from 2% to 6% and thereby slightly increased as 1.79 eV for 8% Ag doping level. For all PbS:Ag films, the photoluminescence spectrum emitted a strong near band edge (NBE) emission at approximately 580 nm, meaning better optical quality. Hall effect measurements evidenced that Ag doping provides enhancement on the characteristics of mobility, carrier concentration, and resistivity with p‐type conducting nature. The observed high carrier concentration and low resistivity values were 4.32 × 1014 cm−3 and 80 Ωcm, for 6% Ag‐doped PbS film. The FTO/CdS/PbS:Ag heterostructure solar cell was formed from 6% Ag‐doped film.

Efficient electron injection in non-toxic silver sulfide (Ag2S) sensitized solar cells

Boosting the Efficiency of SnS Solar Cells Through Reactively Sputter-Deposited Ag-Nanostructured Layer/SnO2 Film at Glancing Angles

Silver sulfide thin film solar cells: materials, fabrication methods, devices, and challenges

Thin‐Film Solar Cells of an Indium‐Modified Silver Antimony Sulfide Selenide Absorber Prepared by Spray Pyrolysis

Facile in situ synthesis of dendrite-like ZnO/ZnTe core/shell nanorod heterostructures for sensitized solar cells

Thiol-Free Synthesis of Bright Near-Infrared-Emitting Ag 2 S Nanocrystals through Heterovalent-Metal Decoration for Ecofriendly Solar Cells

Ag‐doped PbS thin films by nebulizer spray pyrolysis for solar cells

Applying Silver Tellurite to Optimize Ag/Si Contact Interface in Silicon Solar Cells

Silver-assisted Optimization of Band Gap Gradient Structure of Cu(In,Ga)Se2 Solar Cells Via SCAPS

Silver Bismuth Sulfoiodide Solar Cells: Tuning Optoelectronic Properties by Sulfide Modification for Enhanced Photovoltaic Performance

Improved sequentially processed Cu(In,Ga)(S,Se)2 by Ag alloying

Origin of Photovoltage Enhancement via Interfacial Modification with Silver Nanoparticles Embedded in an a-SiC:H p-Type Layer in a-Si:H Solar Cells

A novel silver-doped nickel oxide hole-selective contact for crystalline silicon heterojunction solar cells

Improved Electrical Performance of Low-Temperature-Cured Silver Electrode for Silicon Heterojunction Solar Cells

Energetic Alignment in Nontoxic Sns Quantum Dot-Sensitized Solar Cell Employing Spiro-Ometad As the Solid-State Electrolyte

Over 10% Efficiency Pure Sulfide Kesterite Solar Cells on Transparent Electrode with Cd-Ag Co-Alloying

Substitution of Ag for Cu in Cu2ZnSn(S,Se)4: Toward Wide Band Gap Absorbers with Low Antisite Defects for Thin Film Solar Cells

A Strategy to Optimize Nickel Oxide/Crystalline Silicon Heterocontact of HJT Solar Cells

SnS x Se 1– x /Ag Nanosheet Thin Films for Solar Energy Water Splitting