Abstract:In order to adapt hydrotalcite based sorbents (LDO) to high temperature CO2 sorption and suitable temperature for tar steam reforming, the addition of CaO was investigated, maintaining their structure to keep porosity and accessibility but mostly assure the CO2 sorption stability during sorption/desorption cycles. In co-precipitation synthesis, various interlayer anions with different sizes and valences (carbonate, oxalate, and stearate) and various pH values were studied for different Mg/Ca ratios. The characterization of these sorbents (LDO) by TGA, XRD, N2 adsorption, SEM, sorption capacity, and sorption/desorption stability (cyclic TGA) permitted to understand the effect of the various synthesis conditions and to highlight the interest of oxalate use as interlayer anion. Typical LDH sand roses were formed with carbonate and oxalate anions after calcination until Mg/Ca/Al ratio = 1/2/1. For carbonate, this optimal ratio reached the highest sorption capacity and CaO sites accessibility at 600°C, better than pure CaO. However, the best stability during cycles was obtained with the sorbent from oxalate and Mg/Ca/Al ratio = 1.5/1.5/1 at pH 10 for which sorption results were almost the best values observed. For these two samples, the observed macroporosity were associated to the highest specific surface area and pore volume.Statement of NoveltyIn hydrotalcite structure, a width interlayer space permits to integrate various anions (CO32-, SO4-2, or NO3-) in order to modify CO2 sorption kinetics and capacity. The spheroidal “sand rose” morphology observed with CO32- anions explained the large BET surface area and the better CO2 sorption capacity. Stearate (and longer molecules) exchange was extensively studied as long-carbon-chain organic anion and allowed a better CO2 capture performance.This work focuses on another interlayer anion (oxalate) with the same valence of carbonate (2), a shape and valence different to stearate (1), and not yet reported in the literature. The novelty is to demonstrate that oxalate can replace carbonate as interlayer anion and moreover stearate by a less toxic one.

High-Performance Co2 Adsorbent from Inter Layer Potassium-Promoted Stearate-Pillared Hydrotalcite Precursors

Design, characterization and scale-up test of a high performance pre-combustion CO2 adsorbent

A new nano CaO-based CO2 adsorbent prepared using an adsorption phase technique

Organic Anion Modified K-Promoted Hydrotalcite Adsorbent

Development of carboxyl-layered double hydrotalcites of enhanced CO 2 capture capacity by K 2 CO 3 promotion

Aqueous miscible organic-layered double hydroxides with improved CO 2 adsorption capacity

Facile, Low-Cost, and Sustainable Preparation of Hierarchical Porous Carbons from Ion Exchange Resin: an Improved Potassium Activation Strategy

K‐Promoted Hydrotalcites for CO2 Capture in Sorption Enhanced Reactions

Elevated Pressure CO2 Adsorption Characteristics of K-promoted Hydrotalcites for Pre-combustion Carbon Capture

Dynamic Intermediate-Temperature CO2 Adsorption Performance of K2CO3-Promoted Layered Double Hydroxide-Derived Adsorbents

Hydrothermal synthesis of K2CO3-promoted hydrotalcite from hydroxide-form precursors for novel high-temperature CO2 sorbent.

Self-Assembled Core-Shell Structure MgO@TiO2 as a K2CO3 Support with Superior Performance for Direct Air Capture CO2

Potassium-Promoted Γ-Alumina Adsorbent from K2CO3 Coagulated Alumina Sol for Warm Gas Carbon Dioxide Separation

Synthesis, Pelleting, and Performance Evaluation of a Novel K-Promoted Γ-Alumina/mgal-layered Double Oxide Composite Adsorbent for Warm Gas H2/CO2 Separation

Enhancement of CO2 Adsorption Performance on Hydrotalcites Impregnated with Alkali Metal Nitrate Salts and Carbonate Salts

Study on CO2 Capture Performance by Potassium-Promoted MgAl-Hydrotalcite Adsorbent

Adsorption Separation of CO2 from Flue Gas by Hyperbranched Solid-Amine

Development of a high temperature CO2 sorbent based on hydrotalcite for a H2-rich syngas production from biomass.

Synthesis of Elevated Temperature CO2 Adsorbents from Aqueous Miscible Organic-Layered Double Hydroxides

Evaluation of the Behavior of Hydrotalcite Like-Materials for CO2 Capture

Cost-effective carbon-based amine adsorbents for carbon capture: Equilibrium, kinetics and selectivity