Abstract:The prediction of soil sinkage under wheels and tracks is of significant importance for determining the off-road vehicle performance and level of compaction of agricultural soils. Bekker's theory for pressure and sinkage relationship has been widely applied to estimate the vehicle mobility performance for designing off-road vehicles for deformable terrains. However, the Bekker's constants, which reflect the soil sinkage and behaviour of soil under load, vary significantly among soils. There is a paucity of studies on paddy soils in the plastic state. Furthermore, the determination of soil stiffness constants via pressure-sinkage tests is usually time-consuming. In this study, the impact of three soil physical properties, including soil water content, clay content, and density, on the soil stiffness constants for sinkage behaviour in paddy soils was assessed based on experimental results. Subsequently, numerical models were established to quantify the Bekker's stiffness constants measured from soil bin tests using soil physical properties. Three quadratic polynomial regression models were established and evaluated to quantify the three constants using soil water content, clay content, and density. The P values from goodness of fit tests suggested significant fit (p < 0.01) and insignificant unfit (p > 0.05) between the simulated and experimental results. The established models were further validated using the soil samples with different physical properties. The comparisons between soil stiffness constants predicted using the model with laboratory-measured values indicated satisfactory model performances (R-2 > 0.9). In this study, a simple and promising method was established to estimate soil stiffness constants using easy-to-measure soil physical properties. The model can provide a sound basis for the design and development of agricultural machinery in muddy and wet paddy fields. (C) 2020 IAgrE. Published by Elsevier Ltd. All rights reserved.

Estimating Penetrometer Resistance and Matric Potential from the Velocities of Shear and Compression Waves

A Novel Approach to Estimate Soil Penetrometer Resistance from Water Content, Bulk Density, and Shear Wave Velocity: A Laboratory Study on a Loamy Sand Soil

Semi-analytical solution of pore-water pressure in unsaturated ground and infinite slope considering highly nonlinear soil hydraulic properties

Predicting Penetrometer Resistance from the Compression Characteristic of Soil

Quantification of the Soil Stiffness Constants Using Physical Properties of Paddy Soils in Yangtze Delta Plain, China

The effects of compaction and soil drying on penetrometer resistance

A consistent derivation of soil stiffness from elastic wave speeds

Estimating Hydraulic Conductivity of Naturally Sedimented Clays Using Compression Curves

Estimating Mechanical Parameters of Hydrate-Bearing Sediments on Basis of Shear Wave Velocity Under Triaxial Compression

Resistance of full-flow penetrometers in rate-dependent and strain-softening clay

Assessing the Bearing Capacity of Backfills by Stress Wave Velocity and Cone Penetration Resistance

Bearing Capacity Estimation of Soil under A Constructed Building by Rayleigh Wave Method

A New Empirical Model for the Undrained Shear Strength of Undisturbed Marine Fine-Grained Soil Based on Piezocone Penetration Tests

Measurement of Small Strain Shear Modulus of Clean and Natural Sands in Saturated Condition Using Bender Element Test

Study on Monitoring and Estimating Soil Physical Properties Using Piezoceramic Transducer

Compressional Wave Velocity and Its Physical Nature in Saturated Soils with Extreme Permeability Values

A binary packing material-based method for estimating small-strain shear modulus of sandy soils

Influence of Penetration Rate on Measured Resistance with Full Flow Penetrometers in Soft Clay

Characterization of soil stiffness anisotropy at small strains based on phase velocities of shear waves measured by novel testing apparatus

Influence of Penetration Rate on Full-Flow Penetrometer Resistance in Underconsolidated Clay

An Improved Method of Evaluating Liquefaction Potential with the Velocity of Shear-Waves