Abstract:<p>Full-flow penetrometers (ball and T-bar) are widely used for measurements of strength characteristics of clayey soils in offshore field investigations and laboratory tests. However, the accuracy of the estimated undrained shear strength is hampered by: (1) the drastic variation of the bearing factor for the penetrometer at shallow and transitional penetration depths where full-flow mechanisms are not achieved; and (2) the strain-softening of the soil, which results in a degradation of the estimated strength. This study conducted LDFE analyses to simulate the entire penetration process of full-flow penetrometers in strain-softening soils from shallow to deep embedment depths. Parametric studies were performed to investigate the effects of varied factors on the bearing factor and failure mechanism during the penetrometer penetration. Based on the LDFE analyses, empirical formulas are established to represent the critical penetration depths in the strain-softening soil, which are used to correct the bearing factor at shallow penetration depths. The discrepancies of the transitional failure mechanism and the trapped cavity bearing factor between ball and T-bar are emphasized. Finally, a back-analyses framework is proposed to estimate the strength parameters (including the original undrained shear strength prior to any strain-softening, and the strain-softening parameters) based on the measurements of the penetrometer during the first penetration from shallow to deep embedment depths. Through a series of model tests, the reliability of the back-analyses framework is validated.</p>

Resistance of full-flow penetrometers in rate-dependent and strain-softening clay

Assess the Effects of Loading Rate and Interface Roughness on T-bar Penetration Resistance

Modelling T-bar Penetration in Soft Clay Using Large-Displacement Sequential Limit Analysis

Numerical investigations into cycling of full-flow penetrometers in soft clay

Interpreting strength parameters of strain-softening clay from shallow to deep embedment using ball and T-bar penetrometers

Influence of Penetration Rate on Full-Flow Penetrometer Resistance in Underconsolidated Clay

Influence of Penetration Rate on Measured Resistance with Full Flow Penetrometers in Soft Clay

Strain softening parameters estimation of soft clay by T-bar penetrometers

Investigation of Penetration Process of Three Full-flow Penetrometers in Marine Soft Clay

The Strength Assessment for T-bar Penetrometer Tests at Shallow Embedment in Clay considering Strain Softening

Wetting-induced Softening Behavior of an Unsaturated Expansive Clay

Shear strength characteristics of an unsaturated expansive clay

Interpreting strength parameters in soft clays from a new free-fall penetrometer

An improved evaluation method for the undrained shear strength of uniform soft clay in the nonfull flow state based on ball penetration simulations

Coupled analysis of full flow penetration problems in soft sensitive clays

COUPLING EFFECTS OF INITIAL SHEAR STRESS AND LOADING RATE ON STRENGTH BEHAVIORS OF SATURATED SOFT CLAY

Estimating Penetrometer Resistance and Matric Potential from the Velocities of Shear and Compression Waves

Modeling Temperature-Dependent Behavior of Soft Clay

A novel T-bar test method ensuring full-flow mechanism in stiffer clay