Abstract:Displacement piles are driven to support a wide range of structures. However, analysis of the stress and strain fields developed during their installation remains one of the most challenging problems in geotechnical engineering. Advances in design methods, particularly for sand sites, have had to rely on an imperfect analogy between pile and cone penetration test (CPT), rather than modeling pile installation itself. Recent physical model experiments have provided benchmark data sets that describe the stress and deformation patterns developed around displacement piles penetrating sand masses. Following from large-deformation finite-element analyses that captured the stresses measured in the Grenoble 3S-R calibration chamber NE34 sand experiments, this paper presents simulations of the displacements measured in equivalent high-quality experiments conducted at Purdue University with dense, angular #2Q-ROK silica sand. A modified Mohr-Coulomb model with state-dependent parameters was calibrated to match element tests conducted by the authors, and an arbitrary Lagrangian-Eulerian scheme was applied in the simulations. The evolution and distribution of the deformations induced by pile penetration are compared with the experiments. Predictions for the deformation and strain fields applying during and after pile installation are presented, showing broad agreement between the simulations and experiments. The predicted and measured pile capacities are also compared and contrasted. Points of divergence between the simulations and tests are highlighted and their implications for numerical modeling are discussed.

Influence of Installation Method on Post-Installation Residual Stress in Preformed Piles

Simulation of Post-Installation Residual Stress in Preformed Piles Based on Energy Conservation

ANALYSIS OF RESIDUAL STRESS ON PILE-BASE POST GROUTING PILE

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Large-Deformation Finite-Element Simulation of Deformation and Strain Fields Resulting from Closed-End Displacement Pile Installation in Sand

Stresses Developed Around Displacement Piles Penetration in Sand

Settlement of composite ground reinforced by deformable piles

Study on causes of post-construction settlement of DJM pile composite foundation at bridge approaches

Field Studies on Effect of Jacked Pile on Adjacent Buildings and Roads in Clay

Improved Computational Method Based Upon Slip-line Field Theory For Passive Plies For Practical Use

Influences of different replacement ratios on composite foundation with rigid-flexible piles

Analysis of stress and failure mechanism on composite foundation improved by rigid piles under flexible foundation considering damage of piles

STUDY OF COMPACTING SOIL DISPLACEMENTS AROUND JACKED SINGLE PILE BASED ON EXCESS PORE PRESSURE DISSIPATION

A Large Deformation Finite Element Investigation of Pile Group Installations with Consideration of Intervening Consolidation

EFFECT OF EXCAVATION BENEATH EXISTING BUILDINGS ON LOADING STIFFNESS OF PILES

Model Test on Load Transfer Mechanism of a Static Drill Rooted Nodular Pile

Finite Element Analysis of Compacting Displacements of Single Jacked Pile

Influence Of Excavation Unloading On Vertical Bearing Behavior Of Existing Pile Groups

Influence of Vacuum Preloading on Vertical Bearing Capacities of Piles Installed on Coastal Soft Soil

Analysis Of Deformation And Internal Force For Single Pile Under Combined Vertical And Lateral Loads Considering Yielding Of Soil

Field Tests and Simplified Calculation Method for Static Drill Rooted Nodular Pile