Abstract:The equivalent circuit simulation plays an important role in the design of ultrasound transducer. However, the existing methods are difficult to achieve the effect of matching and backing layer, and not able to accurately simulate the transducer with cable. Especially in the application of high frequency ultrasound, the long cable has a great influence on the performance of the transducer. To overcome these limitations, this paper proposed an improved equivalent circuit method, which combined Leach model and transmission line model. It can realize the complete simulation of ultrasound transducer with a long cable, matching layer, and backing layer in PSPICE circuit simulation software when the parameters were measured. Its principles were briefly introduced, and ultrasound transducers with different frequencies (12 and 20 MHz), different matching layers, and different cable lengths (0.5–2.5 m) were designed and fabricated to verify the effectiveness of the method, which is also compared with the traditional KLM method using PiezoCAD. The experiment results showed that the long cable, matching layer, and backing layer have a significant impact on the performance of high frequency ultrasound transducers, and this proposed method has good agreement with these results. Moreover, for the simulation of the complete transducer, the effect of this method is better than KLM model. Besides, this method does not need to know the specific equivalent circuit of matching, backing layer, or cable wire, it can accurately predict the impedance and phase of the transducer through the material parameters, which is very helpful for the material selection and optimization of subsequent transducer design and fabrication. The study indicates that this improved equivalent circuit method is suitable to be applied in the general circuit simulation software and provides strong support for the high frequency transducer and system design.

The Simulation of Impedance-Frequency Characteristics for Filter-Loaded Output Circuit of Klystrons by Probe-Technique

Gap-Impedance Simulation of Output Circuit with Filter in Transmission Method

Parallel Simulation of Electromagnetic and Thermal Characteristic in RF Component

Numerical Simulation for Vibration of Interferometric Probein Wet Steam Flow Field

Electromagnetic-Thermal Co-simulation of Microstrip Filter

On the Design of a New Simulated Inductor Using a Contactless Electrical Tomography System As an Example

Parallel Multiphysics Simulation for Characterizing Performance Degradation of RF Components

Compact dual-band bandpass filter using asymmetrical dual stub-loaded open-loops

Analytical Modeling for Probe Impedance Using Reflection and Transmission Theory in Eddy Current Testing

Analytical Modeling for Transient Probe Response in Pulsed Eddy Current Testing

Modeling and Analyzing High-Order Modes in Periodic-Stub-Loaded Stripline for Wideband Filter Design

A New Scheme of Embedded RF Probe an Embedded Three-Port Loop of RF Parameters Detection

Inspection of defects in conductive multi-layered structures by an eddy current scanning technique: Simulation and experiments

Study on Shunt Active Power Filter with High Quality Grid Current Waveform

Pre-simulation Method and Its Application for Real-Time Digital Closed-Loop Testing

[Study on the Method of Testing the Wall Filter Performance].

High Frequency Circuit Simulator Based on Finite Element Method

Recent Development to High-Frequency Circuit Simulator

SPICE Circuit Model of the kA Pulsed Current Injection Probe

Dynamic Compensation Strategy for Scanning Error of Contact Probe Based on Damping Ratio and Frequency Mapping

An Improved Equivalent Circuit Simulation of High Frequency Ultrasound Transducer