Abstract:Abstract The presence of clutter in through‐the‐wall images significantly degrades image quality and hampers the performance of algorithms used for data processing in tasks such as target detection, identification, or reconstruction. Real building walls exhibit inherent inhomogeneities, featuring varying frequency and spatial properties that defy the assumption of a smooth surface. Consequently, they produce nonuniform wall surface reflections at each scanning position. Furthermore, these walls often incorporate supply pipes that introduce substantial clutter, which, although stronger than the target responses, remains weaker than the wall surface clutter. Additionally, this clutter often exhibits signatures similar to those of the target. In real‐world scenarios, target reflections can manifest as wide, flat hyperbolas or nearly straight lines, and they may be positioned near the wall. Consequently, distinguishing targets from clutter becomes a complex challenge. Various clutter reduction methods have been proposed in recent years, showing varying degrees of success. However, the effectiveness of these methods in the literature is inconsistent and sometimes contradictory. To address this issue, a comprehensive investigation of well‐established clutter reduction methods was conducted to evaluate their performance under identical conditions. These methods were rigorously assessed using practical radar‐measured data acquired in the presence of actual building wall materials and contrasting targets. Evaluation criteria include the target‐to‐clutter ratio and peak signal‐to‐noise ratio. The results of the experiment revealed that independent component analysis outperformed other clutter reduction methods, demonstrating superior performance in mitigating clutter and enhancing target detection.

[Study on the Method of Testing the Wall Filter Performance].

Spectrum Filter Performance Analysis on Near-Infrared High-Spectral-Resolution Lidar

Design Method of High Performance Digital Low-Pass Filter in Harmonic Detection Algorithm

RESEARCH ON DIGITAL FILTERING ALGORITHM USED INMEASUREMENT SYSTEM OF BALANCING MACHINES

Realization and Comparison of Separation Methods for Wall Clutter and Doppler Ultrasound Blood Signals

The comparison of several wall filters in color flow mapping

An Adaptive Wavelet Method for Clutter Rejection of Doppler Signal: A Simulation Study

Numerical Study on Indoor Wideband Channel Characteristics with Different Internal Wall

A Fast Technique to Evaluate Uniformity Conformity to Standards' Requirement for a Reverberation Chamber at the Low End of Test Frequency

Online Testing Method for the Fine Spectral Characteristics of Narrow-Band Interference Filters Based on a Narrow-Linewidth Tunable Laser

The Simulation of Impedance-Frequency Characteristics for Filter-Loaded Output Circuit of Klystrons by Probe-Technique

Study on Clutter Suppression Method of Airborne Conformal Array Radar Based on Multistage Wiener Filter

Study on separation methods for wall clutter and Doppler blood signals

Study on Choosing of Washout Filter Parameters for Flight Simulator

Study on Impedance Match of Switching Power Supply Filter

Performance analysis of signal processing algorithms for wall clutter mitigation and contrast target detection

[Design and Implementation of Projection-Initialized Wall Filter in Ultrasonic Imaging].

Using Optimized Wall Section to Improve Low Frequency Response in a Room

Harmonic And Interharmonic Estimation Using Time-Domain Quasi-Synchronous Sampling Technique And Comb Fir Filter

Performance Analysis of Spread Spectrum Through Wall Radar

An adaptive clutter rejection method based on AR model in color flow imaging