Abstract:<p>A new dynamic model of shrouded blades with elastic support and variable cross-section is derived based on the Timoshenko beam theory, in which factors to be considered include centrifugal stiffening, spin softening, Coriolis force, blade stagger angle, and twist angle. The proposed model (PM) is verified by comparing the dynamic frequency results of the finite element model (FEM) and the PM. An impact-friction model of shrouded blades is established which can take into account the inertia effects of two passive blades. By comparing the vibration response of the two models (PM and FEM), the established impact-friction model is verified. Finally, the influences of normal contact stiffness, blade root support stiffness, and shroud position on the vibration response of the system are analyzed. Meanwhile, bifurcation diagrams, time-domain waveforms, phase diagrams, Poincaré maps, and frequency spectrum are utilized to analyze the nonlinear vibration characteristics of shrouded blades. The results show that the impact and friction between adjacent shrouds will cause the complex nonlinear vibration of the blades. Under small initial gaps, hard nonlinear phenomena can be observed in the vibration response of the shrouded blade. While under small initial preloads, it shows an obvious soft nonlinear phenomenon. Furthermore, with the increase of normal contact stiffness and blade root support stiffness, the resonance peak of the blade-tip flexural displacement decreases. When the shroud is closer to the blade-tip of the blade, the vibration reduction effect of the shrouded blade is better. The active blade experiences the chaos, period-one motion due to the nonlinear behavior of the impact-friction coupling at the adjacent shroud contact interfaces.</p>

Method for Analyzing Two-Dimensional Coupled Vibration of Turbine Blade with Dry Friction Platform Damper

Study on the Forced Torsional Vibration Response of Multiple Rotating Blades with Underplatform Dampers

Analysis on vibration reduction of a rotating dovetailed blade with underplatform damper and installation preload

Study on Discrete Modeling Method of Modal Testing for Turbine Blade

Research on Boundary Conditions of T Steam Turbine Blade by Finite Element Model Analysis

Research on the Influence of Crack Parameters on the Vibration Characteristics of Gas Turbine Compressor Blades

Mitigation of In-Plane Vibrations in Large-Scale Wind Turbine Blades with a Track Tuned Mass Damper

Finite Element Modeling of Nonlinear Active and Passive Dampers Applied to Vibration Controls

Effect of Under-Platform Dampers on the Forced Vibration of High-Speed Rotating Blades

EXPERIMENTAL INVESTIGATION OF THE DYNAMIC CHARACTERISTICS OF THE DAMPED BLADE

Vibration characteristics analysis of a type of turbine disk-blade assembly system in the civil aero-engine

Vibration response analysis of blade-disk dovetail structure under blade tip rubbing condition

Study for the Optimal Design of the Vibration Characterist ics of Damped Blades

Dynamic response analysis of shrouded blades under impact-friction considering the influence of passive blade vibration

A modeling method for a rotor system with an active floating ring squeeze film damper

Analyzing Resonant Response of a System with Dry Friction Damper Using an Analytical Method

Edgewise vibration control of wind turbine blades using roller and liquid dampers

Application of the hard-coating damper on the mistuned blisk for passive vibration reduction

Experimental and Numerical Quantification of the Aerodynamic Damping of a Turbine Blisk

Multi-mode vibration attenuation of mistuned bladed disks by frictional tuned mass dampers array

An approach of micro-slip modeling based on asymmetric contact pressure distribution and its application in nonlinear boundary beam system