Abstract:<p>A new dynamic model of shrouded blades with elastic support and variable cross-section is derived based on the Timoshenko beam theory, in which factors to be considered include centrifugal stiffening, spin softening, Coriolis force, blade stagger angle, and twist angle. The proposed model (PM) is verified by comparing the dynamic frequency results of the finite element model (FEM) and the PM. An impact-friction model of shrouded blades is established which can take into account the inertia effects of two passive blades. By comparing the vibration response of the two models (PM and FEM), the established impact-friction model is verified. Finally, the influences of normal contact stiffness, blade root support stiffness, and shroud position on the vibration response of the system are analyzed. Meanwhile, bifurcation diagrams, time-domain waveforms, phase diagrams, Poincaré maps, and frequency spectrum are utilized to analyze the nonlinear vibration characteristics of shrouded blades. The results show that the impact and friction between adjacent shrouds will cause the complex nonlinear vibration of the blades. Under small initial gaps, hard nonlinear phenomena can be observed in the vibration response of the shrouded blade. While under small initial preloads, it shows an obvious soft nonlinear phenomenon. Furthermore, with the increase of normal contact stiffness and blade root support stiffness, the resonance peak of the blade-tip flexural displacement decreases. When the shroud is closer to the blade-tip of the blade, the vibration reduction effect of the shrouded blade is better. The active blade experiences the chaos, period-one motion due to the nonlinear behavior of the impact-friction coupling at the adjacent shroud contact interfaces.</p>

Analysis on vibration reduction of a rotating dovetailed blade with underplatform damper and installation preload

Study on the Forced Torsional Vibration Response of Multiple Rotating Blades with Underplatform Dampers

Effect of Under-Platform Dampers on the Forced Vibration of High-Speed Rotating Blades

Vibration response analysis of blade-disk dovetail structure under blade tip rubbing condition

EXPERIMENTAL INVESTIGATION OF THE DYNAMIC CHARACTERISTICS OF THE DAMPED BLADE

Analysis of Dynamic Characteristics of Ring Squeeze Film Damper-Rotor System

Dynamic response analysis of shrouded blades under impact-friction considering the influence of passive blade vibration

Nonlinear dynamics analysis of pre-twisted blade with dovetail joint based on a two-dimensional micro-slip friction model

Mitigation of In-Plane Vibrations in Large-Scale Wind Turbine Blades with a Track Tuned Mass Damper

The Analysis of Dynamic Characteristics in Reduction of the Circular Saw Idling Noise

Passive vibration absorbers for vibration reduction in the multi-bladed rotor with rotor and stator contact

Study for the Optimal Design of the Vibration Characterist ics of Damped Blades

Study Of Snubbing Mechanism Using Finite Element Method

Nonlinear vibration response of a helicopter supercritical tail rotor drive shaft equipped with a dry friction damper

Nonlinear dynamics of asymmetrically supported supercritical rotor equipped with a dry friction damper

Application of the hard-coating damper on the mistuned blisk for passive vibration reduction

Edgewise vibration control of wind turbine blades using roller and liquid dampers

Dynamic Characteristics of a Segmented Supercritical Driveline with Flexible Couplings and Dry Friction Dampers

Investigation of the profile of the blade considering machining vibration based on finite element analysis

A modeling method for a rotor system with an active floating ring squeeze film damper

Nonlinear Dynamics and Combination Resonance of a Flexible Turbine Blade with Contact and Friction of Shrouds