Abstract:High-reflectance ohmic contacts to p-GaN are the key for Flip-chip ultra-violet light emitting diode (UV-LED) to improve the external quantum efficiency (EQE), so the kinds of metal or alloy film both ohmic contact and the reflector of light are important to choose the appropriate high-reflectance and low-resistance ohmic contact to p-type GaN. The GaN-based LED samples used were grown by Metalorganic Chemical Vapor Deposition (MOCVD). Four different metal films were deposited on the surfaces of p-GaN and annealed Ni/Au alloy. The thickness of these metal films varied from 30 nm to 840 nm. The reflectance and transmittance of the samples were mea- sured by WGS-9 system. The 2θ scans XRD and surface AFM images of the samples were also observed. As results, when the films' thickness under the 130 nm the reflectance of Ag-deposited samples increased with the increasing thickness and the transmittance decreased at wavelength of 400 nm. The reason of the increasing of reflectance is the reduction of the light transmitted through the films. When the films' thickness over 130 nm, the reflectance of Ag-deposited samples decreasing. From the results of XRD and AFM, the metal film formed multi-layers film and the roughness R_a and R_q increased with the increasing thickness. It is suggested that the diffusion of the multi-layers films is the main reason of reduction of reflectance with the films thickness increasing. Other metal films show the same characteristics as the Ag-deposited films. From the result of reflectance, Al and Ag are the suitable candidates for the reflector, but it is reported that the single Al or Ag films don't make good ohmic contacts on p-GaN. So a thin annealed Ni/Au is adopted to interspersed between the Al or Ag reflector and the p-GaN in order to provide efficient hole injection into the device. From the results of reflectance and I-V curves of Ni/Au/Ag and Ni/Au/Al, the I-V characteristics of Ni/Au/Ag and Ni/Au/Al contacts are similar to this of Ni/Au annealed. However the reflectance of Ni/Au/Ag and Ni/Au/Al contacts is three times higher than that of Ni/Au at wavelength of 400 nm. These results demonstrated that Ni/Au/Ag and Ni/Au/Al can be used as high-reflectance and low-resistance p-GaN ohmic contacts for flip-chip UV-LEDs

Interface and Transport Properties of GaN/graphene Junction in GaN-based LEDs

Graphene/p-AlGaN/p-GaN Electron Tunnelling Light Emitting Diodes with High External Quantum Efficiency

Improved Transport Properties of Graphene/Gan Junctions in Gan-Based Vertical Light Emitting Diodes by Acid Doping

Graphene-Based Transparent Conductive Electrodes for Gan-Based Light Emitting Diodes: Challenges and Countermeasures

Hot Carriers Assisted Mixed-Dimensional Graphene/mos2/p-Gan Light Emitting Diode

Graphene as a Transparent Conductive Electrode in GaN-Based LEDs

Ohmic Contacts in GaN-based Devices

Surface Plasmon Enhanced Graphene/P-Gan Heterostructure Light-Emitting Diode by Ag Nano-Particles

Annealed Ingan Green Light-Emitting Diodes With Graphene Transparent Conductive Electrodes

Hybrid Tunnel Junction–Graphene Transparent Conductive Electrodes for Nitride Lateral Light Emitting Diodes

n- and p-type ohmic contacts at monolayer gallium nitride-metal interfaces.

Enhanced Opto-Electrical Properties of Graphene Electrode InGaN/GaN LEDs with a NiOx Inter-Layer

Finite Element Model of GaN Based LED and the Optimization of the Mesa Structure

Partially Sandwiched Graphene As Transparent Conductive Layer for Ingan-Based Vertical Light Emitting Diodes

Modified Transmission Line Model To Investigate Non-Ohmic Contact Behavior And Its Application On Gan

The design and fabrication of nanostructure on p-type GaN surface for GaN-based LEDs with high light extraction efficiency

High-reflectance Ohmic Contacts to P-Gan of GaN-based Violet LEDs

Study of GaN-Based Light-Emitting Diode (LED) With a Hybrid Surface Structure

Investigation on the Properties of Nonpolar M-Plane GaN-Based Light-Emitting Diode Wafers Grown on LiGaO2(100) Substrates

Enhanced Transport Properties In Inalgan/Aln/Gan Heterostructures On Si (111) Substrates: The Role Of Interface Quality

The Study on the Reflectance and Resistance of Ni/Ag/Ti/Au Electrode Contact to p-GaN