Abstract:SiC/h-BN multiphase ceramics were prepared via spark plasma sintering (SPS) with t-BN and SiC nanopowders as raw materials and B2O3 as a sintering additive. The phase composition and microstructure of specimens were characterized by X-ray diffraction and scanning electronic microscopy. The effect of sintering additive content on the sintering behavior, densification, microstructure and mechanical properties of SiC/h-BN multiphase ceramics was investigated. The results show that the addition of B2O3 can effectively increase the density and mechanical properties at a low sintering temperature. Compared to the samples without B2O3 additive, the B2O3 additive is effective to decrease the initial shrinkage temperature, promote the rearrangement of h-BN flake grains and improve the bonding strength between the grains. The density of multiphase ceramics increases, and the mechanical properties firstly increase and then decrease with the increase of sintering additive content. The relative density and mechanical properties of the sample with 5% B2O3 content are better than those of other samples, and the relative density, flexural strength, fracture toughness and elastic modulus are 96.92%, 274.7 MPa, 2.91 MPa·m1/2 and 127.2 GPa, respectively. However, the excessive addition of B2O3 is not conducive to the improvement of mechanical properties.

Effect of Additive Systems on Sintering Properties of Injection Molded Boron Carbide

Micro powder injection molding of boron carbide components with SiC-Al2O3-Y2O3 sintering additives

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

Effect of B2O3 Addition on Low-temperature Sintering Behavior and Properties of SiC/h-BN Multiphase Ceramics

Effect of Nano SiC on Microstructure and Mechanical Properties of BN-ZrO2-SiC Multiphase Ceramics

Effect of Sintering Temperature on Properties of Porous SiC Ceramics Produced Through Coat-mix/Composite Additives Process

Effects of SiC Platelet and ZrSi2 Additive on Sintering and Mechanical Properties of ZrB2-based Ceramics by Hot-Pressing

Influence of Silicon Addition on the Sintering Behavior and Mechanical Properties of Boron Carbide by SPS Process

Enhanced thermal shock resistance of BN-based composites sintered by hot-pressing with the introduction of nano oxides

New Progress in the Preparation of Sintering and Application of Boron Carbide Ceramics

Effect of the Addition of Carbon on the Sintering Properties of Boron Carbide Ceramics Prepared by Pressureless Sintering

Investigation the Effect of Additive Content and Sintering Temperature on the Mechanical Properties of Clay-Bonded and Glass-Bonded Ceramic Parts Produced by Low Injection Molding Method

Effects of Sintering Additives on Microstructure and Properties of Porous SiC Ceramics with High Porosity

Effect of sintering temperature and holding time on the microstructure and mechanical properties of ZrB2–SiCw composites

Influence of CNTs on the Sintering Behavior and Mechanical Properties of Boron Carbide by SPS Process

Effects of sintering additives on mechanical properties and microstructure of Si3N4 ceramics by microwave sintering

The Effect of CNTs on the Spark Plasma Sintering Densification Behavior and Mechanical Properties of B4C-Si Powders

Effect of ZrB2 powders on densification, microstructure, mechanical properties and thermal conductivity of ZrB2-SiC ceramics

Effects of Adding Methods of YAG on Sintering Behaviour, Mechanical Properties and Microstructure of SiC Ceramic

Effects of Molding Temperature on Properties of Porous SiC Ceramics

The effects of SiC addition on the sintering densification, phases, microstructure and mechanical properties of W