Anisotropy and Asymmetry of As-Extruded AZ31 Magnesium Alloy Deformed under High Strain Rate

MAO Ping-li,LIU Zheng,WANG Chang-yi,WANG Feng

DOI: https://doi.org/10.19476/j.ysxb.1004.0609.2012.05.002

IF: 3.752

2012-01-01

Transactions of Nonferrous Metals Society of China

Abstract:The anisotropy and asymmetry of an as-extruded AZ31 magnesium alloy deformed under high strain rate were investigated by split Hopkison tension(SHTB) and pressure bar(SHPB).The reasons for the anisotropy and asymmetry were analyzed in terms of deformation mechanisms.The tension and compression were conducted along the extrusion direction and transverse direction,respectively.The results demonstrate that the as-extruded AZ31 magnesium alloy exhibits pronounced anisotropy in tension,but the anisotropic behavior is not obvious in compression according to the loading direction and stress state.The anisotropy is considerably apparent rather in tension than in compression and the asymmetry is more pronounced in extrusion direction than in transverse direction.The anisotropy and asymmetry of the as-extruded magnesium alloy are caused by the variety of the deformation mechanisms: the prismatic slip is the main activation system if tension stress is along the extrusion direction,while the pyramidal slip is the control deformation mechanism for tension and compression along the transverse direction.The initial deformation mechanism of compression along the extrusion direction is the tension twinning;when the strain is about 0.08(8%) the tension twinning is exhausted.At this time the main deformation mechanism is changed to be slipping.