Ex-situ EBSD Analysis of Yield Asymmetry, Texture and Twinning Development in Mg–5Li–3Al–2Zn Alloy During Tensile and Compressive Deformation
Xiaoqiang Li,Chunlong Cheng,Qichi Le,Xiong Zhou,Qiyu Liao,Xingrui Chen,Yonghui Jia,Ping Wang
DOI: https://doi.org/10.1016/j.jallcom.2019.07.099
IF: 6.2
2019-01-01
Journal of Alloys and Compounds
Abstract:In this study, Mg–5Li–3Al–2Zn alloy was successfully fabricated by melting and casting followed by hot extrusion at 573 K. The initial extruded Mg–5Li–3Al–2Zn alloy presented a bimodal structure in which both coarse grains and fine grains coexisted. The asymmetry of tension and compression, texture evolution and twinning types in extruded Mg–5Li–3Al–2Zn alloy during axial tensile and compressive deformations were studied. The experimental results showed that the initial texture component of the extruded Mg–5Li–3Al–2Zn alloy was {0001} basal texture, which led to a strong yield asymmetry of tension and compression (TYS/CYS of 1.46). When the alloy was stretched along the axis, the texture changed little. The main deformation was (101¯0) prismatic slip with few {101¯2} extension twins produced in some coarse grains, which resulted in weak strain hardening. When the compression was along the axial direction, the initial stage of compressive deformation was dominated by (0001) basal slip. With the increase in strain, large numbers of {101¯2} extension twins and few {101¯2}-{101¯2} double twins were generated in coarse grains. On the other hand, (0001) planes of some fine grains began to rotate and became perpendicular to ED, resulting in the formation of a weak {1¯21¯0}<101¯0> texture. With further increase in strain, {0001} basal texture was completely transformed into {1¯21¯0} <101¯0> texture. Furthermore, based on theoretical analysis, the extruded Mg–5Li–3Al–2Zn alloy had lower CRSS of prismatic and basal slips compared to other Mg alloys.