Abstract:In this research, the mechanical behaviors of extruded AZ31B Mg plate along normal direction (ND) were investigated over a wide range of strain rates. High strain rate tests were carried out using a split Hopkinson pressure bar at room temperature. The corresponding deformation mechanisms, texture evolution and microstructure changes were analyzed by utilizing optical microscope (OM), X-ray diffraction (XRD), electron backscatter diffraction (EBSD) and transmission electron microscopy (TEM). It is found that the mechanical responses exhibit both sigmoidal hardening and power-law hardening behaviors under compression at high strain rate ranges of 1068-5647 s(-1). The prismatic type textures of the skin layer and center layer of the AZ31B plate determine its mechanical behaviors. The sigmoidal hardening behaviors are resulted from the formation and development of {10-12} extension twinning at the initial stage of deformation. Whereas the power-law hardening behaviors are resulted from non-basal < c+a > dislocation slip dominated the deformation at the initial deformation stage. Experimental results indicate the critical resolved shear stress (CRSS) for extension twinning and non-basal < c+a > dislocation slip are insensitive to strain rate, but the latter CRSS is significantly higher than the former CRSS. The flow stress is insensitive to strain rate if plastic deformation is dominated by extension twinning, while it increases with the increase of strain rate if plastic deformation is dominated by nonbasal < c+a > dislocation slip. Dynamic recrystallization (DRX) took place if the AZ31B plate was compressed at strain ranges of 4737-5647 s(-1), resulting in a decrease in flow stress and a significant increase in ductility. (C) 2016 Elsevier B.V. All rights reserved.

Effect of Strain on the Adiabatic Shear Behaviour of AZ31 Magnesium Alloy

Microstructure evolution and characterization of the adiabatic shear bands in AZ31 magnesium alloy

Adiabatic Shear Behaviour of AZ31 Alloy with Different Grain Size under High-Strain-rate

Effect of Grain Size on Adiabatic Shear Sensitivity of AZ31 Magnesium Alloys

Dynamic plasticity of AZ31 magnesium alloy: Experimental investigation and constitutive modeling

Effects of High Strain Rate on Mechanical Properties of As-extruded AZ61 Magnesium Alloy

Comparison of the Strain Rate Sensitivity in AZ31 and WE43 Magnesium Alloys under Different Loading Conditions

Mechanical Properties and Microstructure Evolution of AZ31 Magnesium Alloy Sheet Subjected to High Strain Rates Loading of Different Orientations

Strain Rate Sensitivity and Adiabatic Shear Deformation of an Advanced Al-Mg Alloy

Effect of Strain Rate on the Mechanical Properties of Magnesium Alloy AMX602

Dynamic Recrystallization and Microstructure Evolution in AZ31 Magnesium Alloy During Thermomechanical Processing

Microstructure Evolution of Adiabatic Shear Band in AZ31 Alloy under Dynamic Compression

Plastic Deformation Mechanisms of AZ31 Magnesium Alloy under High Strain Rate Compression

Asymmetry in the hot deformation behavior of AZ31B magnesium sheets

Microstructure Evolution During High Strain Rate Tensile Deformation of A Fine-Grained Az91 Magnesium Alloy

Theoretical Calculation of Schmid Factor and Its Application under High Strain Rate Deformation in Magnesium Alloys

Deformation Behavior of Az31 Magnesium Alloy at Different Strain Rates and Temperatures

Dynamic mechanical response and microstructural evolution of extruded Mg AZ31B plate over a wide range of strain rates

Research on Strain Rate Effects of AZ31B Magnesium Alloy of Different Orientation Samples

Effect of Strain Rate and Temperature on Dynamic Mechanical Behavior and Microstructure Evolution of Ultra-High Strength Aluminum Alloy

Influence of strain rate on microstructure and formability of AZ31B magnesium alloy sheets