Abstract:In this research, a linear low density polyethylene (LLDPE) was first melt blended with a series of high density polyethylenes (HDPE) with different molecular weights at a fixed ratio of LLDPE/HDPE=90/10 (w/w). The prepared HDPE/LLDPE blends were then injection-molded into specimen bars through a dynamic packing injection molding (DPIM) technique, in which an oscillating shear field was imposed on the melt by two pistons that move reversibly with the same frequency during the packing stage. The crystal morphology, orientation and tensile properties were characterized by scanning electron microscopy, two-dimensional wide-angle X-ray scattering and Instron, respectively. Compared with conventional injection molding, DPIM caused an obvious increase in tensile strength in the injection-molded bars. Interestingly, LLDPE blended with low molecular weight HDPE (LMW-PE) was found to possess much higher tensile strength than that blended with high molecular weight HDPE (HMW-PE). Shish–kebab morphology was observed for all blends obtained, regardless of the molecular weight of the HDPE. However, thicker but shorter lamellae were observed for the LLDPE/LMW-PE blend, corresponding to a higher melting temperature; while thinner but longer lamellae were seen for the LLDPE/HMW-PE blend, corresponding to a lower melting temperature. Furthermore, the phase miscibility between HDPE and LLDPE was found to increase with increasing HDPE molecular weight, which would affect the sensitivity of molecular chains for response to external shear. The changed miscibility, together with the changed entanglement density in different HDPE was responsible for the change in tensile strength and unique crystal morphology of LLDPE induced by adding HDPE.

Structure and properties of HDPE speciality resins for hollow containers

Synthesis, characterization and lubricating effect of long chain branched polydimethylsiloxane-g-polyethylene copolymers

Structure and properties of monomodal PE100 for pipes

Development of special resin HDPE 5500B for profiled bottles

Study on Structure and Properties of Recycled High Density Polyethylene

Synthesis and Characterization of High‐density Polypropylene‐grafted Polyethylene Via a Macromolecular Reaction and Its Rheological Behavior

Study on structure and properties of heat resistance polypropylene special resin

Structure–property relationship in film and blow molding type high‐density polyethylene polymers from a slurry‐process industrial plant

Effect of Short Chain Branches Distribution on Fracture Behavior of Polyethylene Pipe Resins

Studies on the Structure, Morphology and Thermal Properties of HDPE/ Petroleum Resin Blends

Model Simulation and Rheological Research on Crosslinking Behavior of Polyethylene Resin

Study on properties of HDPE/LLDPE/POE blown films

Effect of small amount of ultra high molecular weight component on the crystallization behaviors of bimodal high density polyethylene

Research and Application of Speciality Resin for Rotational Moulding Waterproof Packing Chests

Characterisation of Formulated High-Density Poly(ethylene) by Magic Angle Spinning Nuclear Magnetic Resonance

Mechanical And Rheological Properties Of Lldpe/Hdpe, Lldpe/Eva Blends

Effect of Morphology on the Properties of High Density Polyethylene/Polyamide 6 Composite

Unique crystal morphology and tensile properties of injection-molded bar of LLDPE by adding HDPE with different molecular weights

Modified high-density polyethylene films: preparation, composition and their physical properties

Compatibility evaluation and mechanical properties of isotactic polypropylene/high density polyethylene (iPP/HDPE) blends

Structure Development and Property Changes in High Density Polyethylene During Pan-Milling