Role of Melt Plasticizing Temperature in Morphology and Properties of PE100 Pipes Prepared by a Rotational Shear System
Zexiang Xie,Ning Gao,Zuchen Du,Hao Yang,Kaizhi Shen,Qiang Fu,Xueqin Gao
DOI: https://doi.org/10.1021/acsomega.9b04138
IF: 4.1
2020-06-01
ACS Omega
Abstract:To increase the maximum internal pressure that a polyethylene (PE) pipe can withstand, a novel rotational shear system (RSS) was constructed in this study to fabricate PE pipes with enhanced hoop strength by applying hoop shear on the pipes using a rotational mandrel. The microstructure and morphology with the influences of melt plasticizing temperature on PE pipes processing under rotational shear were investigated indirectly using small-angle X-ray scattering and wide-angle X-ray diffraction (SAXS/WAXD) measurements. In the SAXS patterns, equatorial streaks and meridional scattering peaks were clearly observed in all three samples prepared at different melt plasticizing temperatures, 215, 235, and 255 °C. Their presence indicated that shish–kebab crystals form in rotational shear. Compared to those at the low melt temperature, the increase in the melt temperature enhanced the amount and the dimensions of shish formed. However, the shish also relaxed faster at the high melt temperature. This behavior was attributed to the enhancement of the molecular chain's athletic ability. The hoop tensile strength and the heat resistance of the pipes peaked at the melt plasticizing temperature of 235 °C, 75.2 MPa, 102.4 °C, up 1 MPa, 0.2 °C (compared to the 215 °C) and 7.8 MPa, 3.2 °C (compared to the 255 °C). The axial strength increased with an increase of melt plasticizing temperature. However, the increase of melt plasticizing temperature worsens the inherent good tensile toughness of PE100 pipes as the axial elongation at break decreases.This article has not yet been cited by other publications.
chemistry, multidisciplinary