Abstract:As a newly emerged active flow control technique, micro blowing/suction has shown a great potential in reducing the skin friction of turbulent flows. Throughout comprehensive analyses of active flow control of micro blowing/suction devices for a NACA0015 airfoil by means of CFD technique, the effects on various characteristics such as lift and drag coefficients and separation areas are investigated in this study. The control devices were placed at 12%c, 30%c and 70%c from the leading edge (c is the chord length of the airfoil), respectively. The corresponding trends of flow separation control at these locations were analyzed with a varied range of angle of attacks (AOA). The two- and three-dimensional incompressible unsteady detached-eddy simulation (DES) was used, along with the k-e turbulence model, in solving the flow problem. The numerical computational results have demonstrated that: (1) Installing micro blowing/suction devices near the separation point is more efficient, as blowing can mix the jet flow and the incoming flow to energize the turbulent kinetic energy and suction can mitigate the flow of low turbulent kinetic energy, which leads to a result of reducing the separation. (2) Suction sometime has more effective influence than blowing, when the flow control devices are placed at 12%c and 30%c. When the control device is placed at 70%c, the effects of lift enhancement and drag reduction are almost the same regardless of blowing and/or suction method. When the AOA is less than 18°, both methods can achieve the goal of lift enhancement and drag reduction. When the AOA is larger than 18°, neither blowing nor suction is efficient. (3) The 3-D numerical simulation shows that the vortex structure evolves from a 2-D pattern near the separation point to a 3-D pattern in the downstream. However the characteristics of flow separation control over a 3-D airfoil simulation agrees well with 2-D numerical results. (4) Blowing at 30%c can move the separation point downstream from 70%c to 80%c at AOA=11°.

Study on influence of brackets on the aerodynamic performance of high-lift system

Effects of Micro Blowing/suction Flow Control Devices on a NACA0015 Airfoil

Effects of slat track on the flow and acoustic field of high-lift devices

Influence of Relative Thickness on Static and Dynamic Stall Characteristics and Prediction of Airfoils

Influence of Flap Parameters on the Aerodynamic Performance of a Wind-Turbine Airfoil

Nacelle Strake's Aerodynamic Characteristics Effects on High-lift Configuration of Transport Aircraft

Optimization and Analysis of a Blown Flap Based on a Multielement Airfoil

Mechanism Analysis of Hysteretic Aerodynamic Characteristics on Variable-Sweep Wings

Influence of flaps deflection angle on aerodynamic performance of aircraft

Numerical Evaluations Of The Effect Of Leading-Edge Protuberances On The Static And Dynamic Stall Characteristics Of An Airfoil

Aerodynamic and Aeroacoustic Analysis of SCCH Models of Four High-Lift Configurations Near Stall Angle of Attack

Effect of Jet Parameters on the Aerodynamic Performance for the Wind Turbine Blade

Far-field Aeroacoustic Analysis for Slat of a Two-Dimensional High-Lift Configuration

Influence of Slot on Wind Turbine Airfoil With Trailing Edge Flaps

Numerical Investigation of Leading Edge Flap on Cranked Arrow Wing

Effects of thickness and camber on aerodynamic performance of flapping wings during forward flight

Cfd Validation For High-Lift Devices: Three-Element Airfoil

Numerical Investigation on the Aerodynamic Performance of an Airfoil with Leading-Edge Protuberances

Investigation of coupled aerodynamic characteristics in channel wing propeller configuration

Experimental study on the effect of bionic flap parameters on airfoil aerodynamic performance

Theoretical and experimental study of the spanwise effect of turbulence on the aerodynamic lift on a wing with different aspect ratios