Abstract:A flap mounted on the upper surface of an airfoil, called a 'lift-enhancing effector', has been shown in wind tunnel tests to have a similar function to a bird's covert feathers, which rise off the wing's surface in response to separated flows. The effector, fabricated from a thin Mylar sheet, is allowed to rotate freely about its leading edge. The tests were performed in the NCSU subsonic wind tunnel at a chord Reynolds number of 4 × 10(5). The maximum lift coefficient with the effector was the same as that for the clean airfoil, but was maintained over an angle-of-attack range from 12° to almost 20°, resulting in a very gentle stall behavior. To better understand the aerodynamics and to estimate the deployment angle of the free-moving effector, fixed-angle effectors fabricated out of stiff wood were also tested. A progressive increase in the stall angle of attack with increasing effector angle was observed, with diminishing returns beyond the effector angle of 60°. Drag tests on both the free-moving and fixed effectors showed a marked improvement in drag at high angles of attack. Oil flow visualization on the airfoil with and without the fixed-angle effectors proved that the effector causes the separation point to move aft on the airfoil, as compared to the clean airfoil. This is thought to be the main mechanism by which an effector improves both lift and drag. A comparison of the fixed-effector results with those from the free-effector tests shows that the free effector's deployment angle is between 30° and 45°. When operating at and beyond the clean airfoil's stall angle, the free effector automatically deploys to progressively higher angles with increasing angles of attack. This slows down the rapid upstream movement of the separation point and avoids the severe reduction in the lift coefficient and an increase in the drag coefficient that are seen on the clean airfoil at the onset of stall. Thus, the effector postpones the stall by 4-8° and makes the stall behavior more gentle. The benefits of using the effector could include care-free operations at high angles of attack during perching and maneuvering flight, especially in gusty conditions.

Influence of flaps deflection angle on aerodynamic performance of aircraft

Aerodynamic Optimization of a High-Lift System with Adaptive Dropped Hinge Flap

Optimization and Analysis of a Blown Flap Based on a Multielement Airfoil

Aerodynamic performance of a self-propelled airfoil with a non-zero angle of attack

Experimental study on the effect of bionic flap parameters on airfoil aerodynamic performance

Analysis of the impact of trailing-edge wing flaps on the aerodynamic characteristics and performance of the Diamond DA-20 aircraft

Aerodynamic Analysis of a Flapping Wing Aircraft for Short Landing

Numerical study on technical and conceptual improvements to a civil aircraft trailing-edge flap using passive/active flow control

Investigation of a bio-inspired lift-enhancing effector on a 2D airfoil

Fluid-structure interaction of a bio-inspired passively deployable flap for lift enhancement

The Effect of Torsional and Bending Stiffness on the Aerodynamic Performance of Flapping Wing

Effects of asymmetric stroke deviation on the aerodynamic performance of flapping wing

Aerodynamic performance of flexible flapping wings deformed by slack angle

Feather-inspired flow control device across flight regimes

Experiment study of propulsion-induced flow on aircraft aerodynamics

Passive separation control of a NACA0012 airfoil via a flexible flap

Comparative Analysis of Improved Aerodynamic Performance: Computational Fluid Dynamics Study of the Trailing Edge Morphing Concept Parameters

The Effect of Various Wedge Flap Configurations on the Performance of Wind Turbine Airfoil

Sensitivity Analysis of Wing Geometric and Kinematic Parameters for the Aerodynamic Performance of Hovering Flapping Wing

Analysis of transient aeroelastic response for shipboard articulate rotor

Optimal Settings of Aerodynamic Performance Parameters in Hovering Flight