Abstract:Airplanes stay lifted into the air due to the pressure difference exerted on their wings. Wings of aircraft are designed to generate lift by directing airflow such that it accelerates over the top and presses down more intensely on the underside. Although there exists a substantial body of literature that delves into the significance of airfoil design for improving aerodynamic efficiency, there is a conspicuous dearth of research pertaining to the development of a new airfoil derived from the NACA 23012 aerofoil. To bridge this critical gap in the current body of knowledge, this investigation aims to introduce innovation by crafting an original airfoil, building upon the foundational principles of the NACA 23012 aerofoil. The high-fidelity panel method was used to investigate an operating range of high Reynolds number, Re = 2 × 10 6 . Many reconfigured airfoils have been designed and analyzed using a parametric study in XFLR5. The numerical setup's validity is established through a comparative analysis with Miley's experimental findings, revealing that the setup exhibits errors of less than 4% across all tested cases. Additionally, in a panel dependency test, the setup demonstrates minimal variation, with discrepancies remaining under 1%. To improve the aerodynamic performance of the new airfoils, geometrical parameters, such as, the leading-edge radius, trailing-edge radius, maximum thickness, and maximum chamber of the NACA 23012 were modified. After analyzing multiple cases, the optimum results for each geometric parameter are combined to generate three new airfoils. The final airfoil with the highest lift-to-drag ratio is further analyzed using flaps. The results show that the new airfoil exhibits a 7% higher lift, 5.2% higher sliding ratio than the base foil, and a 46% lower coefficient of moment than the base foil. An analysis performed on a 3D wing constructed with the new airfoil shows its applicability in constructing a light aircraft. This study contributes to providing a proper overview of effective airfoil design and outlines the necessary short procedures.

Optimization and Analysis of a Blown Flap Based on a Multielement Airfoil

Efficient Global Optimization of Advanced Drop-Hinged Flap

Optimization of the double-slot blown airfoil with jet at the leading and trailing edges of the flap

Parametric Research and Aerodynamic Performance Analysis of Wind Turbine Airfoil with Added Flap

Aerodynamic Optimization of a High-Lift System with Adaptive Dropped Hinge Flap

Aerodynamic Optimization of an Adaptive Flap for Next-Generation Green Aircraft

A Study of Multi-Objective Aerodynamic Optimization Design for Variable Camber Airfoils and High Lift Devices

Numerical study on technical and conceptual improvements to a civil aircraft trailing-edge flap using passive/active flow control

A Low Fidelity Method for Flap Aerodynamic Design of a Cranked-Arrow Wing

Influence of Flap Parameters on the Aerodynamic Performance of a Wind-Turbine Airfoil

Fluid-structure interaction of a bio-inspired passively deployable flap for lift enhancement

A new optimization approach to improve the overall performance of thick wind turbine airfoils

Passive separation control of a NACA0012 airfoil via a flexible flap

Aerodynamic Analysis of a Flapping Wing Aircraft for Short Landing

Design of a Novel Aerofoil of a Light Aircraft for Robust Aerodynamic Performance at High Reynolds Number Regime Using XFLR5

Design and dynamic analysis of a flapping wing air vehicle

AEROELASTIC ANALYSIS ON AN AIRFOIL'S FLUTTER AND FLUTTER CONTROL TECHNIQUE OF BLOWING

Aerodynamic Analysis and Optimization of Embedded Slot for Smooth Morphing Trailing Edge

Wing design optimization and stall analysis with Co-flow Jet active control

An Inverse Design Method for Wing Shape Optimization Guided by Spanwise Lift Distribution

Optimization of Lift Force for a Bio-Inspired Flapping Wing Model in Hovering Flight