Computational and experimental study on the aerodynamic performance of NACA 4412 airfoil with slot and groove
Asif Mahmud Rayhan,Md Shahriar Hossain,Rokeiya Haque Mim,Mohammad Ali
DOI: https://doi.org/10.1016/j.heliyon.2024.e31595
IF: 3.776
2024-05-22
Heliyon
Abstract:Since the Wright Brothers' first flight in 1903, extensive research has been dedicated to improving the aerodynamic performance of aircraft. This study investigates the effect of two distinct wing geometric modifications on airfoil performance at high angles of attack (AOAs). These two modifications are slot, specifically the NACA 4412 with only a slot, and groove, specifically the NACA 4412 with both a slot and a groove. The investigation combines numerical simulation using ANSYS fluent with experimental evaluations conducted in the VDAS AF1300 subsonic wind tunnel. Since turbulent airflow often results in early stall, the primary objective of this research is to delay the stall angle of the normal NACA 4412 airfoil by mitigating local separation zones, and boundary layer transitions. Numerical simulations are performed at airspeeds of 20 m/s and 43.9 m/s, while experimental investigations are conducted at a speed of 20 m/s. The results indicate that both modified airfoils have higher lift-to-drag ratio than the normal airfoil at high AOAs. Specifically, the NACA 4412 airfoil with only a slot demonstrates the highest lift-to-drag ratio among the modified airfoils at high AOAs. Moreover, the NACA 4412 airfoil equipped with a slot and a groove demonstrates the highest stall angle, measured at 18°, compared to the normal NACA 4412 airfoil with a stall angle of 14°. At high AOA, the NACA 4412 airfoil with a slot generates a nearly 35 % higher lift coefficient than the normal NACA 4412 airfoil, while the NACA 4412 with a slot and a groove achieves almost a 16 % higher lift coefficient than the normal NACA 4412 airfoil.