Abstract:Formation of highly crystalline zinc oxide (ZnO) nanowires with an extremely high aspect ratio (length = 60 μm, diameter = 50 nm) is routinely achieved by introducing an intermediate step-oxidation method during the thermal oxidation process of thin zinc (Zn) films. High-purity Zn was deposited onto clean glass substrates at room temperature using a vacuum-assisted thermal evaporation technique. Afterwards, the as-deposited Zn layers were thermally oxidized under a closed air ambient condition at different temperatures and durations. Structural, morphological, chemical, optical and electrical properties of these oxide layers were investigated using various surface characterization techniques such as X-ray diffraction (XRD), scanning electron microscopy (SEM), Raman spectroscopy, and X-ray photoemission spectroscopy (XPS). It was noticed that the initial thermal oxidation of Zn films usually starts above 400 °C. Homogeneous and lateral growth of the ZnO layer is usually preferred for oxidation at a lower temperature below 500 °C. One-dimensional (1D) asymmetric growth of ZnO started to dominate thermal oxidation above 600 °C. Highly dense 1D ZnO nanowires were specifically observed after prolonged oxidation at 600 °C for 5 hours, followed by short-step oxidation at 700 °C for 30 minutes. However, direct oxidation of Zn films at 700 °C resulted in ZnO nanorod formation. The formation of ZnO nanowires using step-oxidation is explained in terms of surface free energy and compressive stress-driven Zn adatom kinetics through the grain boundaries of laterally grown ZnO seed layers. This simple thermal oxidation process using intermittent step-oxidation was found to be quite unique and very much useful to routinely grow an array of high-density ZnO nanowires. Moreover, these ZnO nanowires showed very high sensitivity and selectivity towards formaldehyde vapour sensing against few other VOCs.

Preparation of Nano-Porous Zn and Nanowire-Like ZnO by Anodization and Oxidation

Effects of Electrodeposition Electrolyte Concentration on Microstructure, Optical Properties and Wettability of ZnO Nanorods

Preparation and properties of ZnO nanostructures by electrochemical anodization method

Large-Scale and Rapid Synthesis of Ultralong ZnO Nanowire Films via Anodization

Fabrication and Characterization of Anodic ZnO Nanoparticles

Fabrication of ZnO/Al2O3 core–shell nanostructures and crystalline Al2O3 nanotube

Growth Mechanism of ZnO Nanostructures in Wet-Oxidation Process

Self-organized ZnO nanorods prepared by anodization of zinc in NaOH electrolyte

Zinc oxide nanostructures and porous films produced by oxidation of zinc precursors in wet-oxygen atmosphere

Preparation of a ZnO Nanostructure as the Anode Material Using RF Magnetron Sputtering System

A Novel Simplified Method for Preparing Zno Nanoneedles Via H2o2 Pre-Oxidation

Non-Aqueous Cathodic Electrodeposition of Large-Scale Uniform Zno Nanowire Arrays Embedded in Anodic Alumina Membrane

Preparation and characterization of bat-like ZnO micro- and nanorods by adjusting oxygen flux

Netlike Nanostructures Of Zn(Oh)F And Zno: Synthesis, Characterization, And Properties

Field Emission from Zno Nanostructures Prepared by Electrodeposition

Room-temperature fabrication of highly oriented ZnO nanoneedle arrays by anodization of zinc foil

Studies of Electrochemical Synthesis of Ultrathin ZnO Nanorod/Nanobelt Arrays on Zn Substrates in Alkaline Solutions of Amine−Alcohol Mixtures

Synthesis of Alumina Nanowires and Nanorods by Anodic Oxidation Method

Structural and Optical Properties of Porous ZnO Nanorods Synthesized by a Simple Two-Step Method

ZnO Nanoparticle Films Prepared by Oxidation of Metallic Zinc in H2O2 Solution and Subsequent Process

Surface energy and stress driven growth of extremely long and high-density ZnO nanowires using a thermal step-oxidation process