Abstract:Replacing ordinary concrete in partially encased concrete (PEC) columns with high-strength and durability reactive powder concrete (RPC) significantly improves their axial capacity and suppresses local buckling of the steel section. To study the axial mechanical performance of partially encased composite reactive powder concrete (PEC-RPC) columns after exposure to high temperatures, axial compression tests of eight PEC-RPC column specimens were designed and conducted. Thermal response, failure modes, axial load-vertical displacement curves, and strain-axial strain curves of different specimens were observed considering the effects of link spacing, cross-sectional dimensions, constant temperature duration, and cooling methods. Results indicate: PEC-RPC columns exhibited whitening on the surface of RPC after high-temperature exposure, specimens with the largest link spacing experienced RPC peeling due to concentrated thermal stress, exacerbated by spraying water, which created a stress difference between the surface and the interior, resulting in RPC peeling. The deeper the thermocouple was embedded, the lower the measured temperature. Additionally, due to the significantly lower thermal conductivity of RPC compared to steel, the temperature at measurement points within the RPC is much lower than that at the steel web. The failure mode of PEC-RPC columns after axial loading was characterized by the crushing of RPC and local buckling of section steel. The larger the link spacing, the more prone it was to multi-layer buckling, and columns with larger cross-sectional sizes tended to exhibit shear failure. The characteristic value of mechanical performance showed higher sensitivity to cross-sectional dimensions, but relatively lower sensitivity to link spacing and constant temperature duration. As the cross-sectional dimensions increased from 150×150 mm to 250×250 mm, the peak load, residual bearing capacity, stiffness, and ductility increased by 72.51–164.86 %, 89.8–173.6 %, 61.85–151.47 %, and 13.72–31.46 %, respectively. Finally, based on partition constraint theory and superposition principle, a simplified method for calculating the axial mechanical performance of PEC-RPC columns after exposure to high temperatures was proposed.

Impact Mechanical Properties of Reactive Powder Concrete after Exposure in High Temperature

Dynamic Behavior of Reactive Powder Concrete in Split Hopkinson Pressure Bar Testing

Experimental study on impact properties of reactive powder concrete using shpb after exposure in high temperature

Study on Dynamic Mechanical Behavior and Constitutive Model of Reactive Powder Concrete after Exposure in High Temperature

Dynamic Behavior for Steel-Fiber Reinforced Reactive Powder Concrete after Exposure in High Temperature

Experimental investigation on the dynamic tensile behavior of graded steel-fiber RPC

Experimental study on dynamic behavior of concrete at elevated temperatures

Effect of Fibers on High-Temperature Mechanical Behavior and Microstructure of Reactive Powder Concrete

The Effect on Dynamic Properties of Reactive Powder Concrete under High Temperature Burnt and Its Micro-Structure Analysis

Experimental Research the Shearing Performance of Grading-Fiber Reinforced Reactive Powder Concrete

Experimental Study on the Spalling Strength of Fiber Reactive Powder Concrete

EXPERIMENTAL RESEARCH ON IMPACT BEHAVIOR OF CONCRETE-FILLED STEEL TUBE AT ELEVATED TEMPERATURES

Tests on impact behaviour of concrete-filled steel tube after exposure to high temperatures

Experiment Investigation for Dynamic Behavior of Hybrid Fiber Effects on Reactive Powder Concrete

Comparative analysis of dynamic mechanical properties of steel fiber reinforced concrete under ambient temperature and after exposure to high temperatures

Effects of High Temperature and Substitution Rates of Fly Ash on the Mechanical Properties and Microstructures of Steel-Basalt Hybrid Fibers Reinforced Cementitious Composites

Performance of reactive powder concrete with different fiber varieties at higher temperatures and retention periods

Experiment on Thermophysical Properties of Reactive Powder Concrete

Axial compressive behavior of partially encased composite reactive powder concrete columns after high-temperature exposure

Investigation on Concrete-Pcm Interface under Elevated Temperature: at Material Level and Member Level

Experimental Investigation of Heating–cooling Effects on the Mechanical Properties of Geopolymer-Based High Performance Concrete Heated to Elevated Temperatures