Abstract:To increase the accuracy of an analytic method based on the concentrated-mass approach for solving the mechanical operating modal characteristics of complete impellers and impellers with balancing holes in a centrifugal-pump rotor system, we establish a mathematical model and a three-dimensional simulation model for a double-supported three-stage centrifugal-pump rotor system. By comparing the modal results obtained from the two models, we propose a mathematical model that integrates the optimization of mass-distribution methods and bending stiffness correction coefficients, and we derive an optimized mathematical model for rotors with balancing holes. The effectiveness of the optimized mathematical model is validated via three-dimensional simulation, and the influence of balancing holes on the wet modes is analyzed. The results show that the wet natural frequencies are lower than the dry ones and that the wet natural frequencies obtained from analytical calculations are consistently higher than those obtained from three-dimensional simulation results. The optimized mathematical model significantly improves the accuracy of the wet modal characteristics for both complete impellers and impellers with balancing holes, with the errors in the low-order natural frequencies reduced by more than 50%. Under the same hole spacing, the natural frequencies of the three-stage centrifugal pump rotor system decrease with increasing hole diameter slightly. Under the same hole diameter, the natural frequencies of the rotor system increase slightly with the hole spacing. The effect of stiffness changes caused by balancing holes on the natural frequencies is larger than the effect of mass changes.

Modeling and Analyzing the Main Modes of an Ultra-Precision Stage with Lumped Parameter Method

Mathematic Model of Simultaneously Measuring Six-dimensional Parameters by Laser

Preliminary Exploration on Control Theory of Ultraprecision Stage with Large Travel

Structured Uncertainty Modeling of Position-Dependent Model Variations for an Ultra-Precision Stage

LFT-Structured Uncertainty State-Space Modeling for State Feedback Robust Control of the Ultra-Precision Wafer Stage

Modeling and analyzing for ultra-precision coarse-fine stage

Finite Element and Experimental Modal Analysis of Ultra-Precision Air Bearing Linear Motion Stage

Operational modal identification of ultra-precision fly-cutting machine tools based on least-squares complex frequency-domain method

LFT Structured Uncertainty Modeling and Robust Loop-Shaping Controller Optimization for an Ultraprecision Positioning Stage

Modeling and Control for a Long-Stroke 4-PPR Compliant Parallel Mechanism

Theoretical Modeling and Verifications of Unit Structure Method

Wafer Stage Modal Model Identification by Modified Vector Fitting Method

Modular Kinematics and Statics Modeling for Precision Positioning Stage

Error modeling and analysis of an ultra-precision stage with an aerostatic bearing

Integral Sliding Mode Based Precision Motion Control for PMLM.

Coupled Dynamic Modeling and Analysis of Ultra-precision 6-DOF Fine Stage

Modeling and Identification of Iron-Less PMLSM End Effects for Reducing Ultra-Low-velocity Fluctuations of Ultra-Precision Air Bearing Linear Motion Stage

State/Model-Free Variable-Gain Discrete Sliding Mode Control for an Ultraprecision Wafer Stage

System Identification, Modeling and Precision Motion Control of a Linear Motor Drive Stage

Mechanics mode characteristics analysis and numerical analytical optimization study of a three-stage centrifugal pump

Sequential Structure and Control Co-design of Lightweight Precision Stages with Active control of flexible modes