Abstract:In the field of CNC milling, chatter has been a hot research topic, which is related to machining quality, precision and cost. Stability lobe diagram (SLD) reflects the vibration of the machining system under different process parameters and cutter axis vectors that is significant for optimization. The accurate dynamic characteristics of the machining system is the prerequisite for stability analysis. Finite element simulation is mainly aimed at small diameter cutter system, and accuracy is poor. The most widely used method is hammer test, but the equipment is expensive, the operation is too professional and it cannot reflect the dynamic characteristics of the machining system in working status. This paper proposes an undetermined coefficient method for the general cutter system to identify the modal parameters, that are the natural frequency, stiffness and damping ratio, just based on the very simple experiment of three-axis half-immersion milling in horizontal plane. Firstly, considering the exact in-cut cutting edge and the instantaneous cutting force coefficient corresponding to the axial factor and the chip thickness, the dynamic model of three-axis milling machining for the general cutter is established. Secondly, two implicit conditions of stable critical speed and cutting depth are derived based on feedback control theory in the frequency domain. Thirdly, the two sets of critical cutting depth and the chatter frequency under arbitrary speeds are obtained by using the dichotomy. With the method proposed in this paper, one of the two is used to solve a series of modal parameter sets, and the other of the two is used to extract the optimal modal parameters in the modal parameter sets. Finally, taking the identified modal parameters as known conditions to search the points one by one in the two-dimensional space composed of the rotational speed and the cutting depth, and judge whether it meets the critical conditions. SLD can be obtained by connecting the points that satisfy critical conditions together. Based on the previous experiment of flat-end cutter, it verified the feasibility of the modal parameter identification method in the paper. In the designed three-axis milling experiment of the ball-end cutter, the in-cut cutting edge simulation and the cutting force coefficient identification were carried out, and the modal parameters of the cutter system were also obtained successfully. The plotted lobe diagram was verified by the spectrum analysis result of the vibration signal collected by the acceleration sensor.

Operational modal identification of ultra-precision fly-cutting machine tools based on least-squares complex frequency-domain method

A Multi-Task Learning-Based Automatic Blind Identification Procedure for Operational Modal Analysis

A complete methodology for identifying dynamics of heavy machine tool through operational modal analysis

Modal parameter identification of general cutter based on milling stability theory

Operational modal analysis based dynamic parameters identification in milling of thin-walled workpiece

Operational modal analysis of a machine-tool structure during machining operations

Operational Modal Analysis of CNC Machine Tools Based on Flank-Milled Surface Topography and Cepstrum

Dynamic simulation and active vibration control design of an ultra-precision fly-cutting machine tool

Modal Parameter Identification of Electric Spindles Based on Covariance-Driven Stochastic Subspace

Research on the dynamic characteristics of the ultra-precision fly cutting machine tool and its influence on the mid-frequency waviness of the surface

Fully automated precise operational modal identification

A New Modal Analysis Method Applied to Changing Machine Tool Using Clustering

Estimation of vibration stability in milling of thin-walled parts using operational modal analysis

Investigation of a cutting state-independent method for identifying in-process frequency response functions of the micro milling system

Modal Identification of Multi-Degree-of-freedom Structures Based on Intrinsic Chirp Component Decomposition Method

Dynamics Modelling and Simulating of Ultra-precision Fly-Cutting Machine Tool

High-accurate Cutting Forces Estimation by Machine Learning with Voice Coil Motor-Driven Fast Tool Servo for Micro/nano Cutting

Output-Only Time-Varying Modal Parameter Identification Method Based on the TARMAX Model for the Milling of a Thin-Walled Workpiece

Hybrid multibody system method for the dynamic analysis of an ultra‐precision fly‐cutting machine tool

Experimental Modal Analysis of Horizontal Machine Tools

Damping identification using weighted fitting of Frequency-response-function (WFF) method