Abstract:Porous Y-α-SiAlON ceramics were prepared by freezing camphene-based suspensions at 0°C and subsequently sintering at 1900°C for 1h. The effects of solid loading content in the suspensions on porosities and formation of α-SiAlON as well as mechanical and dielectric properties of the porous ceramics were investigated. An XRD analysis performed on sintered samples indicated that the α-SiAlON did not fully form in the sample with initial solid loading content of 10vol%, due to the high porosity of 90vol% and interconnected pore of the green body. With the increase of initial solid loading content from 10vol% to 30vol%, the porosity decreased from 62.3% to 23.1% and the average pore size decreased from 19μm to 8μm. As a result, the flexural strength increased significantly from 72.4MPa to 190.2MPa, fracture toughness increased from 1.20MPam1/2 to 3.48MPam1/2, as well as the dielectric constant increased from 3.3 to 6.3. The dielectric loss (tanδ) of obtained material varied between 1.4×10−2 and 2.8×10−2, which did not depend on the porosity of samples.

Fabrication Of Gradient Porous Beta-Sialon Ceramics Via A Camphene-Based Freeze Casting Process

Pore Architectures And Mechanical Properties Of Porous -Sialon Ceramics Fabricated Via Unidirectional Freeze Casting Based On Camphene-Templating

Pore Architectures and Mechanical Properties of Porous α-SiAlON Ceramics Fabricated via Unidirectional Freeze Casting Based on Camphene-Templating

Effects of Solid Content on the Phase Assemblages, Mechanical and Dielectric Properties of Porous Α-Sialon Ceramics Fabricated by Freeze Casting

FABRICATION OF POROSITY GRADIENT ALUMINA CERAMICS BY THE CENTRIFUGAL CASTING METHOD

Fabrication of Porous Alumina Ceramics with Directional Pore Channels Structure by Freeze-Gel Casting Processing

Aligned and porous alumina ceramics prepared by camphene-based freeze-casting route: microstructure and properties

Microstructure and Mechanical Properties of ZrB2–SiC Porous Ceramic by Camphene-Based Freeze Casting

Synthesis of Porous α-Al_2O_3 Ceramics by Freeze-Casting Processing

Highly Porous Zro2 Ceramics Fabricated by A Camphene-Based Freeze-Casting Route: Microstructure and Properties

Effects of pore shape and porosity on the dielectric constant of porous β-SiAlON ceramics

Functionally Graded Porous Ceramics with Dense Surface Layer Produced by Freeze-Casting

Ultra-high-porosity Zirconia Ceramics Fabricated by Novel Room-Temperature Freeze-Casting

Preparation and properties of high-porosity ZrB2-SiC ceramics by water-based freeze casting

Fabrication of Ceramics with Complex Porous Structures by the Impregnate–Freeze‐Casting Process

The controllable microstructure of porous Al2O3 ceramics prepared via a novel freeze casting route

Cost-effective Fabrication of Porous Α-Sialon Bonded Β-Sialon Ceramics

POROUS Β-Sialon/si3n4 CERAMICS PREPARED BY REACTIVE SINTERING

Fabrication of Gradient Porous SiC Ceramics with Directional Pores Without Templates

Effect of Solid Content on Pore Structure and Mechanical Properties of Porous Silicon Nitride Ceramics Produced by Freeze Casting

Processing, Microstructures and Mechanical Properties of Aqueous Gelcasted and Solid-State-Sintered Porous Sic Ceramics