Abstract:The heat dissipation of power amplifier (PA) chips is one of the biggest challenges in the development of miniaturized state of art glass-based high-power RF modules. Glass has excellent electrical properties, but the extremely poor thermal conductivity of it also brings many barriers in the application. Its (quartz glass) thermal conductivity is only 1/93 of that of silicon, so there will be a problem of poor heat dissipation. In recent years, there has been an increasing amount of literature on microfluidic cooling technology and this method was demonstrate as an efficient way in cooling application. In this article, we designed, fabricated, and tested a Si-Glass microchannel heat sink, which took advantage of the high thermal conductivity of silicon to deal with the insufficient thermal conductivity of the glass interposer. Finite element simulation was used to study the thermal property of the Si-Glass heat sink and a multi-parameter optimal method was used to design the geometrical parameters, including the number of flow channels and other geometrical parameters of the heat sink. Then the aforementioned microchannel heat sinks were fabricated using cleanroom fabrication on 4-inch silicon and glass wafers. To complete the thermal test, the Thermal Demonstration Vehicles (TDVs) were fabricated by bonding the sample onto a customized PDMS holder for fluid connections with the flow loop. A programmable power source was used to heat the TDV in a stepwise manner, and a syringe pump was used to supply the liquid to cool the heat sink. Results show that the heat sink can dissipate heat flux greater than 150W/cm2with substrate temperature lower than 100°C.

Studies on Average Power Handling Capacity of SIW with Heat Transfer Theory

The Frequency-Dependent Average Power Handling Capability Of Metal-Insulator Semiconductor (Mis) Microstrip Interconnects

Wide-band characterization of average power handling capabilities of some microstrip interconnects on polyimide and polyimide/GaAs substrates

Wideband Average Power Handling Capability of Coupled Microstrips on Polyimide and Polyimide∕gaas Substrates

Average Power Handling Capability of Quarter-Wavelength Microstrip Stepped-Impedance Resonator Bandpass Filter

Frequency-Dependent Maximum Average Power-Handling Capabilities of Single and Edge-Coupled Microstrip Lines on Low-Temperature Co-Fired Ceramic (ltcc) Substrates

Average Power-Handling Capability Of The Signal Line In Coplanar Waveguides On Polyimide And Gaas Substrates Including The Irregular Line Edge Shape Effects

A New Type of Periodically Loaded Half-Mode Substrate Integrated Waveguide and Its Applications

Finite-Ground Thin-Film Microstrip Interconnects (tfmis) and Their Power Handling Capabilities over Ultra-Wide Frequency Ranges

An Experimental Study of Microchannel and Micro-Pin-Fin Based On-Chip Cooling Systems with Silicon-to-Silicon Direct Bonding.

Analysis of Substrate Integrated Waveguide Structures Using Contour Integral Equation

Embedded heat pipe SiC interposer for distributed power devices

The Visualized Investigation of a Silicon Based Built-in Heat Pipe Micropillar Wick Structure

The Art of Substrate-Integrated-Waveguide Power Dividers

Average power handling capability on SiON thin film coplanar waveguide interconnections for MMICs

Design. Fabrication, and Test of an Embedded Si-Glass Microchannel Heat Sink for High-power RF Application

Study on the Thermal Interface Resistance of the Helix Slow-Wave Structure

Guided-wave and leakage characteristics of substrate integrated waveguide

Half Mode Substrate Integrated Waveguide: A New Guided Wave Structure For Microwave And Millimeter Wave Application

An Evaluation of Heat Dissipation Capability of Slow-Wave Structures

Numerical Study on Hybrid Discontinuous Microchannel Heat Sink Combining Manifold with Pin Fins (DMC-MPF) for High Power Electronic Device