Abstract:Cross-axis sensitivity of single-axis optomechanical accelerometers, mainly caused by the asymmetric structural design, is an essential issue primarily for high performance applications, which has not been systematically researched. This paper investigates the generating mechanism and detrimental effects of the cross-axis sensitivity of a high resoluion single-axis optomechanical accelerometer, which is composed of a grating-based cavity and an acceleration sensing chip consisting of four crab-shaped cantilevers and a proof mass. The modified design has been proposed and a prototype setup has been built based on the model of cross-axis sensitivity in optomechanical accelerometers. The characterization of the cross-axis sensitivity of a specific optomechanical accelerometer is quantitatively discussed for both mechanical and optical components by numerical simulation and theoretical analysis in this work. The analysis indicates that the cross-axis sensitivity decreases the contrast ratio of the interference signal and the acceleration sensitivity, as well as giving rise to an additional optical path difference, which would impact the accuracy of the accelerometer. The improved mechanical design is achieved by double side etching on a specific double-substrate-layer silicon-on-insulator (SOI) wafer to move the center of the proof mass to the support plane. The experimental results demonstrate that the modified design with highly symmetrical structure can suppress the cross-axis sensitivity significantly without compromising the sensitivity and resolution. The cross-axis sensitivity defined by the contrast ratio of the output signal drops to 2.19%/0.1g from 28.28%/0.1g under the premise that the acceleration sensitivity of this single-axis optomechanical accelerometer remains 1162.45V/g and the resolution remains 1.325 mu g. (C) 2016 Optical Society of America

Analysis and Improvement of A 3 Axis Accelerometer

Analysis of the Frequency-Dependent Vibration Rectification Error in Area-Variation-Based Capacitive MEMS Accelerometers.

Analysis and Amelioration about the Cross-Sensitivity of A High Resolution Moems Accelerometer Based on Diffraction Grating

Mechanical Design Optimization of A Single-Axis Moems Accelerometer Based on A Grating Interferometry Cavity for Ultrahigh Sensitivity

Minimizing cross-axis sensitivity in grating-based optomechanical accelerometers.

Accurate mechanical-optical theoretical model of cross-axis sensitivity of an interferometric micro-optomechanical accelerometer

A New Type of MEMS Accelerometer with Up-Tuning Structure

Design And Implementation Of A Novel Cmos-Mems Single Proof-Mass Tri-Axis Accelerometer

Implementation of A Monolithic Single Proof-Mass Tri-Axis Accelerometer Using Cmos-Mems Technique

Design and Simulation for Tri-Axial Piezoresistive Mems Accelerometer

Design and Fabrication of a Highly Symmetrical Capacitive Triaxial Accelerometer

Analysis On Twin-Mass Structure For A Piezoresistive Accelerometer

Modeling and Simulation of A Silicon Integration Tri-Axial Piezoresistive MEMS Accelerometer Chip Used for High Impact Test

A Low Cross-Axis Sensitivity Micro-Grating Accelerometer With Double-Layer Cantilever Beams

Design and simulation of a novel MEMS-based single proof mass three-axis piezo-capacitive accelerometer

Analysis of the Mechanical Coupling Characteristics of a Monolithic Tri-Axis MEMS Gyroscope

Development of a High-Precision and Low Cross-Axis Sensitivity 3-D Accelerometer for Low-Frequency Vibration Measurement

A new structure and modeling of a three-axis MEMS capacitive accelerometer with high dynamic range and sensitivity

A Three-Axis CMOS-MEMS Accelerometer Structure With Vertically Integrated Fully Differential Sensing Electrodes

Design And Analysis Of Mems Biaxial Coupled Resonance Accelerometer

Design and Analysis of a Multi-Finger Micromechanical Silicon Accelerometer