Joining Aluminum to Titanium Alloy by Friction Stir Lap Welding with Cutting Pin

Yanni Wei,Jinglong Li,Jiangtao Xiong,Fu Huang,Fusheng Zhang,Syed Hamid Raza

DOI: https://doi.org/10.1016/j.matchar.2012.05.013

IF: 4.537

2012-01-01

Materials Characterization

Abstract:Aluminum 1060 and titanium alloy Ti–6Al–4V plates were lap joined by friction stir welding. A cutting pin of rotary burr made of tungsten carbide was employed. The microstructures of the joining interface were observed by scanning electron microscopy. Joint strength was evaluated by a tensile shear test. During the welding process, the surface layer of the titanium plate was cut off by the pin, and intensively mixed with aluminum situated on the titanium plate. The microstructures analysis showed that a visible swirl-like mixed region existed at the interface. In this region, the Al metal, Ti metal and the mixed layer of them were all presented. The ultimate tensile shear strength of joint reached 100% of 1060Al that underwent thermal cycle provided by the shoulder.