Abstract:When unbalanced insulation is applied to double circuit transmission lines on the same tower,the minimum degree of insulation unbalancedness,by which the lower insulation level is configured at one of the double circuit transmission lines to ensure that the phase-to-phase flashover always occurs at the side with the lower insulation level,is analyzed by electromagnetic transient program(EMTP),and a corresponding insulation configuration scheme is provided.When the balanced insulation or the insulation with low unbalancedness is adopted to double circuit transmission lines on the same tower,the inter-circuit flashover caused by lightning stroke usually happens,namely there is a single-phase flashover in each circuit,however along with the extension of the difference in insulation levels for the two circuits,the inter-circuit flashover gradually turns to phase-to-phase flashover happening at the circuit with the lower insulation level.Based on this principle and by means of ensuring enough difference between insulation levels for the two circuits,it can make sure that when double circuit transmission lines on the same tower is lightning-stricken the phase-to-phase flashover only happens at the circuit with the lower insulation level,therefore the serious fault of simultaneous trip-out of two circuits can be avoided at the cost of trip-out of one circuit.Calculation results show that when the degree of insulation unbalancedness for double 220 kV or 110 kV circuit transmission lines on the same tower reaches to 30%,or in other word,the difference in insulator pieces of a string between two 220 kV circuits or two 110 kV circuits is 4 or 3 pieces respectively,the unbalanced insulation can restrict the circuit,where phase-to-phase flashover happens.Besides,the effect of such a measure is reliable and suitable for double circuit transmission lines on the same tower with various conductor arrangements of phase sequence to avoid simultaneous trip-out of both circuits for double circuit transmission lines on the same tower due to lightning stroke.

Study on unbalance factor of sequence impedance for parallel multi-circuit cable lines

Investigation on Circulation Current Calculation and Grounding Methods of Multi-circuit Cables

Research on Compensation and Protection of Voltage in Metal Shield of 110kv Power Cable under Three Segments Unsymmetrical State

Investigation on Steady State Characteristics and Loss Reduction Measures of 220 Kv Power Cables

Steady-state Electrical Properties and Loss Reduction Measures Analysis for 220 Kv Tunnel Cable System

Sheath Loss Calculation and Loss Reduction Analysis of 220 Kv Cable System

Grounding System Analysis of 220 Kv Power Cable Lines Installed Underneath a Bridge

Analysis and Calculation of Crosstalk for Twisted Communication Cables in Umbilical Cable

Improvement Measures for Electric Unbalance of Double-Circuit Transmission Lines on Same Tower

Cable Sheath Loss Analysis Based on Coupled Line Model

Research on optimized phase sequence arrangements for 500 kV quadruple-circuit transmission line on the same tower

Traveling-wave Differential Relay Scheme for Double-circuit Parallel Lines on the Same Pole

Comparison of Different Methods for Calculating Electrical Parameters of Power Cables

Analysis and Experimental Validation of Power Distribution Network with Multi-slots Parallel-Plane Structure

Application of Unbalanced Insulation in 220 Kv and 110 Kv Double-Circuit Transmission Lines on the Same Tower

Simulation Analysis of Grounding Characteristics of Cable Based on ATP-EMTP

Comparison of long cable impedances using multiphysics and equivalent circuit models

Spectrum Optimization of Multi-conductor Power Cable for the Power-line Communications

Rayleigh-Schrödinger perturbation analysis of signal propagation modes in inhomogeneous multi-conductor power cables

Transmission Line Modeling and Crosstalk Analysis of Multibraided Shielded TWP/Twinax Cables

Comparison of Methods for Suppressing Circulating Current in Metal Sheath of Cables Connected in Parallel