Abstract:As a kind of widely used optical material, optical glass BK7 is machined by first grinding and then polishing in industrial production. However, the polishing process is time-consuming and high-cost. Therefore, it is very meaningful to produce high-quality BK7 workpieces by grinding. To understand the grinding characteristics of BK7, many studies were conducted and reported. But most studies available so far had low industrial relevance and were difficult to be applied to guide real production of BK7 glass. To fill this gap, in this study, BK7 grinding characteristics are investigated and special emphasis is laid on the effects of machining parameters in terms of machined surface morphology, subsurface damage, and grinding force. Results show that wheel depth of cut plays the most important role in BK7 grinding, and a little difference of it leads to completely different material removal modes. Wheel speed is the second important parameter. It cannot change the dominant removal mode but can slightly adjust the characteristics of machined surface, subsurface damage, and grinding force. Workpiece feed rate has a small impact on BK7 grinding. From the viewpoint of industrial application, it suggests that the wheel depth of cut of 1.0 μm, high wheel speed, and high workpiece feed rate are more rational and practical because under this condition the grinding process can produce BK7 workpieces, which possess crack-free surface and sublet subsurface damage, with high removal rates and stable grinding forces. The findings of this paper are expected to be meaningful to provide the experimental references for the studies of the BK7 grinding process and guide industrial production of BK7 optical components.

Relationship Between Surface Roughness and Subsurface Crack Depth During Grinding of Optical Glass BK7

Prediction and Verification Analysis of Grinding Force in the Single Grain Grinding Process of Fused Silica Glass

Study on the Model of Surface Crack Depth in Ceramics Grinding

Subsurface damage evaluation in the single abrasive scratching of BK7 glass by considering coupling effect of strain rate and temperature

Analysis on Ground Surface Damage of Quartz Fiber-Reinforced Quartz Composites

Grinding damage of BK7 using copper-resin bond coarse-grained diamond wheel

Influences of polishing tool's shape on surface roughness in magneto-rheological finishing

Experimental investigation on grinding-induced surface damage of Fiber Reinforced Ceramic Matrix Composites

Experimental investigation on grinding characteristics of optical glass BK7: with special emphasis on the effects of machining parameters

Experimental Research on the Effect of Grinding Parameters on Ceramic Machined Surface Roughness

A Study on Grinding Surface Waviness of Woven Ceramic Matrix Composites

Investigation of Surface Integrity Induced by Ultra-Precision Grinding and Scratching of Glassy Carbon

Estimation of the Surface Roughness of K9 Optical Glass in Precision Grinding Using the Brittle Material Removal Fraction Based on an Improved Image Processing Algorithm

Study on the material removal mechanism and the exit breakage of ultrasonic vibration-assisted grinding for microcrystalline glass

Theoretical modeling and experimental analysis of single-grain scratching mechanism of fused quartz glass

Characterization of glass surface damaged by alumina abrasive grains

Model for Predicting the Micro-Grinding Force of K9 Glass Based on Material Removal Mechanisms

Research on microscopic fracture mechanism of glass-ceramics grinding surface based on progressive scratch test

Surface and subsurface microscopic characteristics in sapphire ultra-precision grinding

Study on machining BK7 optical glass by ultrasonic vibration-assisted polishing considering the micro-contact state of the abrasive particles with the workpiece

Roughness of oxide glass subcritical fracture surfaces