Abstract:This study examines the laser-stricken damage to different alumina ceramic surfaces of different roughness through multi-physical field coupling simulations and laser-striking experiments. The surfaces of different morphologies can be described by waves of different frequencies and amplitudes, and the waves which are discretized can be described by rectangular microstructures of different heights. In this paper, we found that the reaction of roughness surfaces to gauss lasers stricken on them could be simulated by the reaction of rectangular microstructures of different heights to laser strike. The simulation was carried out through the multi-physical field coupling method. The distribution of temperature and stress on rectangular microstructure were examined after being treated by high energy laser. It was found that overhigh temperature and stress were the main causes of laser-stricken damage, but there existed a critical rectangular column height value. The microstructure became increasingly prone to damage and fall-off with the increase of the rectangular column's height, but it became decreasingly prone to damage after the rectangular column reached the critical value. In the experiments, seven roughness zones of alumina ceramic layer were chosen as sample surfaces for laser-striking experiment. The results showed that there was a critical roughness value at a fixed laser energy density. As a result, the amount of particles falling off the surfaces caused by laser strike was rising when the roughness was increasing. However, the amount of particles falling off the surfaces was decreasing after roughness reached the critical value. The critical rectangular column height value in the simulation corresponded to the critical roughness value in the experiment. Therefore, an appropriate selection of roughness is an important factor for obtaining high laser-stricken damage threshold.

Characterization of glass surface damaged by alumina abrasive grains

Theoretical and experimental investigation on surface generation and subsurface damage in fixed abrasive lapping of optical glass

Method of Damage Characterization of Engineering Ceramics Grinding Surface

Prediction and Verification Analysis of Grinding Force in the Single Grain Grinding Process of Fused Silica Glass

Investigation of Surface Integrity Induced by Ultra-Precision Grinding and Scratching of Glassy Carbon

Subsurface damage evaluation in the single abrasive scratching of BK7 glass by considering coupling effect of strain rate and temperature

Study on Laser-Stricken Damage to Alumina Ceramic Layer of Different Surface Roughness

Generation of Scratches and Their Effects on Laser Damage Performance of Silica Glass

Influence of Sliding Speed and Glass Bead Concentration on 3D Roughness Parameters

Grinding damage of BK7 using copper-resin bond coarse-grained diamond wheel

Experimental Investigation on Laser-Induced Surface Damage Threshold of Nd-Doped Phosphate Glass

Assessment of sub-micron subsurface damage in glass

Reduced threshold ultraviolet laser ablation of glass substrates with surface particle coverage: A mechanism for systematic surface laser damage

Roughness of oxide glass subcritical fracture surfaces

The Competing Effect of Initial Crack Depth Versus Chemical Strengthening Parameters on Apparent Fracture Toughness of Sodium Aluminosilicate Glass

Preparation of α-alumina/polymethacrylic acid composite abrasive and its CMP performance on glass substrate

Hardness and scratch resistance of chemically strengthened alkali‐borosilicate thin glass

Crystallographic and morphological textures in laser surface modified alumina ceramic

Influence of Glassy Carbon Surface Finishing on Its Wear Behavior during Precision Glass Moulding of Fused Silica

Experimental Investigation and Modeling of Friction Coefficient and Material Removal During Optical Glass Polishing

Aluminium Nitride Surface Characterization by Grinding with Laser-Ultrasonic Coupling