Abstract:A simple and general Equivalent Dynamic Stiffness Mapping technique is proposed for identifying the parameters or the mathematical model of a nonlinear structural element with steady-state primary harmonic frequency response functions (FRFs). The Equivalent Dynamic Stiffness is defined as the complex ratio between the internal force and the displacement response of unknown element. Obtained with the test data of responses׳ frequencies and amplitudes, the real and imaginary part of Equivalent Dynamic Stiffness are plotted as discrete points in a three dimensional space over the displacement amplitude and the frequency, which are called the real and the imaginary Equivalent Dynamic Stiffness map, respectively. These points will form a repeatable surface as the Equivalent Dynamic stiffness is only a function of the corresponding data as derived in the paper. The mathematical model of the unknown element can then be obtained by surface-fitting these points with special functions selected by priori knowledge of the nonlinear type or with ordinary polynomials if the type of nonlinearity is not pre-known. An important merit of this technique is its capability of dealing with strong nonlinearities owning complicated frequency response behaviors such as jumps and breaks in resonance curves. In addition, this technique could also greatly simplify the test procedure. Besides there is no need to pre-identify the underlying linear parameters, the method uses the measured data of excitation forces and responses without requiring a strict control of the excitation force during the test. The proposed technique is demonstrated and validated with four classical single-degree-of-freedom (SDOF) numerical examples and one experimental example. An application of this technique for identification of nonlinearity from multiple-degree-of-freedom (MDOF) systems is also illustrated.

Joint Dynamic Properties Identification with Partially Measured Frequency Response Function

A Joint Stiffness Identification Method Based on Finite Element Modeling and Frequency Response Functions

Damping identification using weighted fitting of Frequency-response-function (WFF) method

Simulation and Experiment Study on System Identifications of Elastically Jointed Structures

Estimation of Joint Parameters Using Frequency-Based Substructuring Techniques

A principle of selecting points for identifying joint part parameters of a drum-disk structure based on frequency-response functions

Joint Identification through Hybrid Models Improved by Correlations

Measurement and identification of the nonlinear dynamics of a jointed structure using full-field data; Part II - Nonlinear system identification

Improved Method for Frequency-Domain Identifications of Structures

Equivalent Dynamic Stiffness Mapping Technique for Identifying Nonlinear Structural Elements from Frequency Response Functions

Closed-Loop Dynamic Parameter Identification of Robot Manipulators Using Modified Fourier Series

Comparative Assessment of Frequency Dependent Joint Properties Using Direct and Inverse Identification Methods

Identification of Robot Joint Torsional Stiffness Based on the Amplitude of the Frequency Response of Asynchronous Data

An Integrated Joint Dynamics System for Elastically Jointed Structures

Modal Parameter Identification Based on Multi-Axis Vibration Environment Test

Coherence Analysis Method for Dynamic Force Identification

Various damper forces and dynamic excitation nonparametric identification with a double Chebyshev polynomial using limited fused measurements

Non-Linear System Identification Using Frequency Domain Measurement Data

Frequency domain identification of modal characteristics and loads from output‐only measurements

Parameter Identification of Flexible Robotic Joint Based on Multi-Sensor Information.

Identification of Instantaneous Frequency and Damping From Transient Decay Data