Abstract:Traditional motor protection methods are conservative, neglecting actual thermal conditions and underutilizing the motor's performance. This paper proposes a novel double neural network model predictive control (DNMPC)-based protection method to maximize motor performance. First, we analyze the system's thermal properties and propose a thermal lemma to demonstrate that solving the protection problem involves determining the maximum allowable control input boundary. Second, instead of directly measuring the motor temperature, the neural network (NN) method is proposed to establish the system's thermal model for estimating the motor temperatures. Third, leveraging the NN model, we propose a model predictive control (MPC) strategy designed to determine the maximum allowable control input boundaries, which we refer to as the neural network model predictive control (NMPC) method. Consequently, this approach has led to the development of an advanced motor protection system. To further reduce the computational burden, we incorporate an additional NN to directly approximate the NMPC controller, thereby forming our proposed DNMPC approach. Finally, comparative experimental validation demonstrates the effectiveness and superiority of the proposed method. The results indicate that the NN model is highly accurate, eliminating the need for direct temperature measurements and enabling the prediction of future motor temperatures. Additionally, the DNMPC-based protection method significantly improves the joint's peak torque output by 64.3% compared to conservative continuous current limited protection methods. The computational efficiency is also notable, with the NMPC achieving a runtime of approximately 20 ms, while the DNMPC achieves only 0.2 ms.

Implementation of Phase-sensitive Protection of Mine-used Motor Based on Single-chip Microcomputer

A Novel Magnetization Failure Detection Method for 1-Phase BLDC Motor Based on Back-EMF Test

Intelligent Protector for Motor Based on PICmcu

Modeling and Realization of Multiphase Permanent Magnet Synchronous Motor Variable Speed System

Design Of Comprehensive Motor Protector Based On Improved Sliding-Window Iterative Dft Algorithm

Research on microcomputer protective device for asynchronous motor

Study of an Intelligent Low-Voltage Integrative Motor Protector Based on PIC16G876 Single Chip

Study of an Integrative Motor Protector Based on Microcontroller

A Multiplexed Current Sensors-Based Phase Current Detection Scheme for Multiphase SRMs

An Efficient Protection Scheme Against Single-Phasing Fault for Three-Phase Induction Motor

Protection of Three Phase Induction Motor Using Embedded System

A Novel Protecting Method For Motor'S Over Current

Design and Experimental Verification of a Short-Circuit Proof Six-Phase Permanent Magnet Machine for Safety Critical Applications

High-Power-Factor Control Of Ipmsm Drive System With Small Dc-Link Capacitor

Analysis of Inter-Turn Short-Circuit Faults in Brushless DC Motors Based on Magnetic Leakage Flux and Back Propagation Neural Network

A novel protection scheme for two-phase faults in power distribution system with neutral ungrounded

Design and Implementation of Protection Relay 3 Phase Induction Motor

Advanced Fault-Tolerant Current Control of Five-Phase Pmsm for Mining Applications

Efficient protection and control of electric drives using solid state circuits

Remedy for open-circuit fault of 4-phase permanent magnet fault tolerant motor

A double neural network model predictive control method for series elastic actuator's motor thermal protection